User`s manual

AssemMy requires two persons. PHaceaHHparts of the eHHpticaHcrosstrainer in a cHeared area and remove the

packing materiaHs, Do not dispose of the packing materiaHs until assembHy is compHeted, In addition to the

included allen wrenches, assembly requires a phillips screwdriver _ _, an adjustable

f ,,

wrench _._ , and a rubber mattet ,_............

)

•........ ] j

Refer to the drawings bellow to identify the smaHHparts needed for assembHy, The number in parentheses bellow

each drawing is the key number of the part, from the PART LHSTon page 22, The number foHHowingthe key

number is the quantity needed for assembHy, Note: Some small parts may have been pre-assembted. If a

part is not found in the parts bag, check to see if it has been pre-assembled.

M8 NyHon M8 SpHit M8,5 SmaHH MIO Washer

Locknut (46)-4 Washer (94)-10 Washer (53)-2 (99)-2

M4 x 16mm

Screw (66)-12

M4 x 16mm Round

Head Screw (45)-1

M4 x 14mm Round

Head Screw (93)-2

M4x 12mm Round

Head Screw (18)-2

M6 x 16mm Tapered M8 x 19mm Shoulder

Button Screw (107)-8 Screw (22)-2

M8 x 38mm Button

Screw (70)-2

M8 x 43mm Button

Bolt (50)-4

M8 x 45mm Button

Screw (102)-4

M8 x 54mm Button

Screw (33)-4

M10 x 35mm Carriage

Bolt (20)-2

M4 x 52mm Screw (98)-2

While another person lifts the front of the Frame (1),

thread a Leveling Foot (72) fully into the underside of

the Frame, Next, attach the Front Stabilizer (3) to the

front of the Frame with two M8 x 54mm Button Screws

(33) and two M8 Split Washers (94),

33 72