Owner's Manual

Inspect and tighten all parts of the elliptical regularly.

eplace any worn parts immediately.

To clean the elliptical, use a damp cloth and a small

amount of mild soap. IMPORTANT: To avoid damage

o the console, keep liquids away from the con-

sole and keep the console out of direct sunlight.

CONSOLE TROUBLESHOOTING

If the console display becomes dim, replace all the

batteries at the same time; most console problems are

the result of low batteries. See assembly step 9 on

page 10 for replacement instructions.

If the console does not display your heart rate when

you use the handgrip pulse sensor, see step 5 on

page 17.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted.

To adjust the reed switch, you must first remove the

Top Shield (20). Using a flat screwdriver, release the

tabs on the front and rear of the Top Shield and then

remove the Top Shield.

Next, locate the Reed Switch (69). Loosen, but do not

emove, the M4 x 16mm Screw (93).

Next, rotate the Large Pulley (74) until a Magnet (75)

is aligned with the Reed Switch (69). Slide the Reed

Switch slightly toward or away from the Magnet. Then,

retighten the M4 x 16mm Screw (93).

Rotate the Large Pulley (74) for a moment. Repeat

these actions until the console displays correct feed-

back.

When the reed switch is correctly adjusted, reattach

the top shield.

MAINTENANCE AND TROUBLESHOOTING