Owner's Manual

12. Attach the Front Upright Cover (25) around the

Upright (5) by pressing the tabs on the Front

Upright Cover into the Rear Upright Cover (24).

14. Make sure that all parts of the elliptical are properly tightened. Note: Some hardware may be left over

after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical.

13. Identify the Right Rear and Front Leg Covers

(29, 30), which are marked with “Right” stickers.

Attach the Right Rear Leg Cover (29) to the

Right Upper Body Leg (6) with three M4 x

16mm Screws (93).

Attach the Right Front Leg Cover (30) around

the Right Upper Body Leg (6) by pressing the

tabs on the Right Front Leg Cover into the Right

Rear Leg Cover (29).

Attach the Left Rear and Front Leg Covers

(31, 32) in the same way.

See step 3. Tighten the four M8 x 16mm Patch

Screws (102).

Then, slide the Top Cover (23) downward and

press it over the Frame (1).