Juke Box Setup Guide Please read before unpacking!
Setup Guide for Juke Box E & S2
Get started: - Make sure you have enough space to unpack your turntable. - Make sure to unpack it in a clean enviroment. - Do not throw packaging away. Important for warranty! More information about the product in the manual.
1 Open the carton and unpack all items from accessory bag.
b) a) e) h) f) g) c) d) i)
2 Remove dust cover carton from the box.
3 Carefully remove the turntable protection insert.
4 Lift the wrapped turntable out of the box.
5 Unpack the power supply.
6 Carefully remove the protection covering.
Remove the platter protection.
8 Put the drive belt on the pulley and platter. Start with the pulley! Small pulley- 33 RPM Big pulley - 45 RPM Important: Make sure to have clean hands when touching the belt. Dirt on the belt can cause it to slip.
9 Install the Bluetooth antenna.
10 Unpack dust cover and put it on the turntable.
11 How to correctly position your speakers. < < < Speakers should be turned towards the listener < For enjoying a perfect stereo image: If the speakers are two meters apart from each other, the listener should sit at a maximum position of three meters, but no futher. For longer distances please use this 2:3 rule.
12 Plug speaker cables into the turntable / connect the power cable. Power cable Speaker cables left and right speaker channel Please note: „L“ out is going to the speaker that you see on your left when you’re looking at your system. „R“ to the right speaker.
13 Remove tonearm twist tie.
14 Turning on the Juke Box.
15 Control of the unit using the knob on the front. Standby Press the knob for 3 seconds to turn the unit on. Input selector Briefly press the knob to switch between Bluetooth > Turntable > Line In Volume Adjust volume by turning the knob.
16 Remove the needle protection cover.
17 Play your records Make sure the tonearm lift lever is in an upright position.
18 Move the tonearm over the lead in groove.
Move the tonearm lever down.
20 Enjoy your music!
