INSTRUCTIONS FOR USE Pro-Ject Debut RecordMaster
) 2 © Pro-Ject Audio Systems · Pro-Ject Debut RecordMaster · Revision 2016.07.
Pro-Ject Debut RecordMaster Controls, features and connections 1 2 3 4 5 6 7 8/18 9 10 11 12 13 14 15 16 17 19 20 21 22 Motor brackets with Ortofon® pads Stepped drive pulley Drive belt * 3a Hook * Sub-platter Platter * Tonearm counterweight * 6a Downforce scale Tonearm lift lever Tonearm rest and removable transport lock Tonearm tube 9a Tonearm base Lid * Lid hinges Hinge fasteners Mains lead Phono output sockets, earth connection and USB-out Anti-skating stub with anti-skating weight adjustment scale Ant
In order to achieve maximum performance and reliability with this record player you should study these instructions for use carefully. Warning of a hazard for the user, the unit or possible misuse. ! Important notice. ** Your turntable has been delivered with a factory fitted and adjusted cartridge, please ignore the cartridge set up instructions unless changing the cartridge at a later date.
Rotate the counterweight counter clockwise (seen from the front) to adjust the downforce according to the cartridge manufacturer's recommendations. One mark on the scale represents 1 mN (= 0,1g / 0,1 Pond) of downforce. Please note: Adjust the downforce prior to installing the anti-skating weight. The recommended downforce for the Ortofon OM 10 cartridge is 15mN. The recommended downforce for the Ortofon 2M Red cartridge is 17,5mN.
from the internet or for any damage or problems arising from the use thereof. All downloads should be checked with an up-to-date anti-virus programme. License fees may be applicable. Mains power connection The turntable is supplied with the universal power supply with 3 exchangeable sockets adapters suitable for all countries. Select the correct adapter for your country and insert the adapter to the exchangeable part of the power supply.
Please note: Under no circumstances should the arm tube be adjusted with the needle still in the record groove! Irreparable damage may be caused to the cantilever suspension! The arm must be lifted to make each adjustment and lowered afterwards to check it. Mounting and connecting the cartridge ** All cartridges with half inch mounting holes can be fitted.
Potential incorrect use and fault conditions Pro-Ject turntables are manufactured to the highest standards and undergo strict quality controls before leaving the factory. Faults that may possibly occur are not necessarily due to material or production faults but can sometimes be caused by incorrect use or unfortunate circumstances. Therefore the following list of common fault symptoms is included. The platter doesn't turn although the unit is switched on: The unit is not connected to the mains power supply.
© Pro-Ject Audio Systems · Pro-Ject Debut RecordMaster · Revision 2016.07.