INSTRUCTIONS FOR USE Pro-Ject Debut Carbon DC
© Pro-Ject Audio Systems · Pro-Ject Debut Carbon / Ortofon OM 10 and Ortofon 2M Red · Revision 2016.07.
Pro-Ject Debut Carbon DC Controls, features and connections 1 2 3 4 5 6 7 8/18 9 10 11 12 13 14 15 16 17 19 20 21 22 Motor brackets with Ortofon® pads Stepped drive pulley Drive belt * 3a Hook * Hub Platter with felt mat * Tonearm counterweight * 6a Downforce scale Tonearm lift lever Tonearm rest and removable transport lock Tonearm tube 9a Tonearm base Lid * Lid hinges Hinge fasteners Power supply socket Phono output sockets and earth connection Anti-skating weight adjustment scale Anti-skating weight * A
on or near the device. Never spill any liquid on the device. Never place any naked flame sources, such as lighted candles on or near the device. The product shall not be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar conditions. Keep plastic bags away from children to prevent any risk of suffocation. Set-up The deck is supplied partially disassembled and carefully packaged for safe transport. Carefully remove all parts from the transport packaging.
Take care to connect the left and right channels correctly. The right channel is usually marked red, the left channel black or white. Check the manual supplied with your amplifier for relevant information. The earthing wire of the tonearm lead should be connected to the earth terminal on your amplifier (if provided).
Please note: Under no circumstances should the arm tube be adjusted with the needle still in the record groove! Irreparable damage may be caused to the cantilever suspension! The arm must be lifted to make each adjustment and lowered afterwards to check it. Fitting and connecting the cartridge ** All cartridges with half inch mounting holes can be fitted.
Dimensions (W x H x D) Weight Dimensions packaging (W x H x D) Weight incl. packaging 415 x 118 x 320mm, dust cover open 415 x 365 x 405mm 5,6kg 488 x 235 x 393mm 8,0kg Technical specifications MM-Cartridge Ortofon OM 10 Frequency range Channel separation Output voltage Recommended load impedance Compliance/stylus type Recommended tracking force Weight 20-22.
Potential incorrect use and fault conditions Pro-Ject turntables are manufactured to the highest standards and undergo strict quality controls before leaving the factory. Faults that may possibly occur are not necessarily due to material or production faults but can sometimes be caused by incorrect use or unfortunate circumstances. Therefore the following list of common fault symptoms is included. The platter doesn't turn although the unit is switched on: The unit is not connected to the mains power supply.
© Pro-Ject Audio Systems · Pro-Ject Debut Carbon / Ortofon OM 10 and Ortofon 2M Red · Revision 2016.07.