Installation Manual

All wires and connections should be secured and away from any moving parts or extremely
hot surfaces. Additionally, they should be properly fused and protected from water, mud and
other outdoor elements.
WIRING
Congratulations on your choice of Pro Armor Sound Bars.This “Quick Start” Installation
guide is meant to help you complete a basic installation. For more detailed information
about the product, please visit our website at ProArmor.com
3.5mm AUX IN
AUDIO OUTPUT
Red - 12v Power
Ignition
Fuse
Busbar
12v Battery
Orange - Remote In Black - Ground Blue - Remote Out
3.5mm AUX IN
AUDIO OUTPUT
Red - 12v Power
Ignition
Fuse
Busbar
12v Battery
Orange - Remote In Black - Ground Blue - Remote Out
All Pro Armor powered audio accessories regire installation. We highly recommend that
you follow this guide as a minimum. If you’re machine is longer, you may want to go 1
gauge thicker on your wiriring for Power and Ground.
You should never connect your Power and Ignitiion wires together. When you do this,
the power on your unit, never turns off and you can damage product and ware down
your battery. A water proof fuse should be installed up high in the machine to avoid
water and mud.
After installing any Pro Armor audio products and before each ride make sure that the
units are properly secured. The last thing you want to do is injure yourself or your audio
equipment while out on the trails. Be mindful that these products may need to be re-
torqued (tightened) after an intense ride.
WIRING & FUSING
MOUNTING PRECAUTIONS
WIRE GAUGE & FUSE REQUIREMENTS
Model Power/Ground Wire Turn On Wire Fuse
Sound Bar 8
Sound Bar 4
Power Speaker Pods
18 gauge
18 gauge
18 gauge
10 gauge
12 gauge
10 gauge
15Amp
10Amp
20Amp
It is very important to note when cleaning your Pro Armor audio products to never use
high pressure washers found at self-serve car washes or “power washers”. If you would
not put the water pressure on your skin, DO NOT put it on your speakers or electronics.
It is ok to use a low pressure gentle streamed hose, quickly. Like a garden hose set for
lowest pressure. Regarding cleaners or cleaning products. Make sure to use a diluted
non-corrosive cleaning product. These can be found at your local automotive parts store
in the car was soap section. If you have heavy or dried on dirt and mud you should use
a soft brush or soft cloth to loosen the dirt.
CLEANING PRECAUTIONS
NO PRESSURE WASHER
NO CHEMICAL CLEANSERS