Use and Care Manual

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

Assembly - Attaching the Fan Blades and Brackets

Fastening the blade brackets to

the motor

□ Mount the fan blade (E) to the blade bracket (F) by aligning

the three key-slot holes in the blade (E) with the three posts

(RR) on the top of the blade bracket (F).

□ Hold the blade (E) with both hands close to the blade

bracket (F) down rmly. Ensure the key-slot holes are

properly seated on the blade bracket posts (RR).

□ While still holding the blade (E) down with both hands, rmly

slide the blade (E) until it engages in the locking mechanism

(SS). Make sure the locking mechanism (SS) at the rear of

the blade bracket (F) springs upward and butts against the

edge of the blade (E), indicating a secure connection.

□ Visually inspect the top of the blade bracket (F) to ensure

the locking mechanism (SS) is securely in place.

□ Repeat this procedure for the remaining blades (E).

Attaching the blades to the blade

brackets

□ Fasten the blade brackets (F) to the fan-motor assembly (B)

by inserting the alignment post into the slot on the bottom

of the motor and tightening the pre-installed blade bracket

screws (QQ) by inserting a screw driver through the access

hole (ZZ).

□ Repeat this step for the remaining blade assemblies by

rotating the motor until the next blade bracket screw can be

accessed through the access hole (ZZ) in the switch cup.

NOTE: Your fan blades are reversible. Select the blade side nish

which best accentuates your decor.

IMPORTANT: The switch cup has an access hole (ZZ) to allow the

screwdriver to reach the screws in the blade bracket. Position

the blade bracket on the motor and tighten by inserting the

screwdriver through the access hole (ZZ).