Bluetooth Speaker User Guide Customer:ODI Product:Top Dogg/Horn Dogg/Remote Version 1.
1. Overview of I/O port: 1.1 Item list: 1. Battery door 2. Aux in 3. TF card 4. Lineout of Decoy 5. Power Button 2 Operation Guide: 2.1 Open Battery door. Connect the cable of special battery. Close Battery door. 2.2 Push Power Button to Turn on the Speaker. 2.3 Waiting signal from Remote control. 2.4 Hold 5s on Power Button of Remote to Turn it on. 2.5 Screen will list out COYOTE/SERNADE/RABBIT. 2.6 Press "HOT1"(for Top Dogg) or "HOT3"(for Horn Dogg) to connect Speaker. 2.
2.9 2.10 2.11 2.12 Screen will list out Sounds/Expert Hunts/Settings Press "Arrow down" or "Arrow up" to "Settings" and press "Enter". Screen will list out Source selection: SD/AUX/BT Press "Arrow down" or "Arrow up" to the target source. The Speaker will change the source automatic. 3 SD Play(Hunts Mode): 3.1 When select source on the Remote, press "Arrow down" or "Arrow up" to "SD". 3.2 Press Menu Back to Main Menu. 3.3 Press "Arrow down" or "Arrow up" to "Sounds". And press "Enter". 3.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver.