CommandPoint 72XR5 and 72XR30 User Guide Complete Coverage for every type of facility SCHOOLS HEALTHCARE GOVERNMENT INDUSTRIAL CORPORATE
CommandPoint 72XR5 and 72XR30 System Manual CONTENTS Product Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 FCC and IC information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Compliance Statements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CommandPoint 72XR5 and 72XR30 System Manual Product Description The CommandPoint 72XR System automatically synchronizes clocks through a wireless radio signal. The GPS satellites transmit time information to the GPS receiver that sets the Transmitter’s internal clock to the precise GPS time. The Transmitter rebroadcasts that time via a radio signal to system clocks and components within the range of the system.
CommandPoint 72XR5 and 72XR30 System Manual License Requirements Operation of the System requires a license, which must be obtained prior to operation. FCC licenses must be renewed every 10 years, and the IC licenses must be renewed annually. As a service, Primex Wireless will file the license application for you.
CommandPoint 72XR5 and 72XR30 System Manual 72XR5 and 72XR30 Specifications: System: • Frequency Range: 72-76 MHz • Enclosure Dimensions: 20.8”W x 17.6”H x 21.4”D (.53mW x 45mH x .54mD) • Approx. Weight: 75 lbs.
CommandPoint 72XR5 and 72XR30 System Manual Equipment Precautions Warning: Primex Wireless disclaims any liability or responsibility for the results of improper or unsafe installation practices. Never operate the Transmitter without the antenna being properly connected to the Transmitter. Operating the Transmitter without an antenna can destroy the Transmitter’s power output and poses a safety risk. Note: Equipment must be installed by a Primex Wireless certified installer.
CommandPoint 72XR5 and 72XR30 System Manual 72XR5 / 72XR30 Antenna Setup and Mounting Warning: The installation, maintenance, or removal of an antenna should only be performed by a Primex Wireless certified installer. System Operation The following assumes that the Transmitter, antenna and GPS receiver have been properly set up as previously described.
CommandPoint 72XR5 and 72XR30 System Manual Daylight Saving Time The Transmitter is pre-programmed to automatically make adjustments for Daylight Saving Time. The letters "DT" (Daylight Saving Time) or "ST" (Standard Time) will be displayed when adjustment for Daylight Saving Time is active (switch #3 in the up position). If neither "DT" nor "ST" is displayed, then switch #3 is in the down position and the Transmitter will not adjust for Daylight Saving Time.
CommandPoint 72XR5 and 72XR30 System Manual Troubleshooting Interference If interference is noticed on televisions, radios or other wireless devices when the system is powered up, a scheduled transmit option is available. This will allow the transmitter to broadcast only at predetermined times, minimizing the possibility for interference. Contact Primex Wireless technical support at 1-800-404-8112 for more information.
CommandPoint 72XR5 and 72XR30 System Manual Note: The use of unshielded or standard shielded cables to extend the distance between the GPS Receiver and the Transmitter beyond 50 feet can cause this failure mode. A special shielded cable with low resistance on the voltage supply line is required for distances over 50 feet. The maximum distance using the special cable is 200 feet. If cable connections are good, replace the GPS Receiver. b.
CommandPoint 72XR5 and 72XR30 System Manual Product Installation/Troubleshooting As was previously stated, this transmitter broadcasts a signal from 39 minutes after the hour to 6 minutes after the hour (except through 11:39pm- 12:06am). After this time, the transmitter’s output will go into standby and the display will indicate SB. Note: In the event of a facility wide power outage the transmitter will broadcast for 8 hours upon the restoration of power. This will synchronize all products.
CommandPoint 72XR5 and 72XR30 System Manual AC Powered Analog Clocks • While using the timed transmit schedule, the clocks will update at 2, 6, and 10 am/pm. If a signal is not received at a specific update time, the clock will continue to search for a signal until it receives one. • If installing clocks after the initial 8 hour transmission, there are 3 options 1. Install clocks between 39 minutes past the hour and 6 minutes after the next hour. They will set right away. 2.
CommandPoint 72XR5 and 72XR30 System Manual Wireless Tone Generator • While using the timed transmit schedule, the wireless tone generator will update between 39 and 6 minutes past the hour. The green LED on the wireless tone generator will flash during this time indicating that it is receiving a signal. • If installing a wireless tone generator after the initial 8 hour transmission, there are 2 options 1.
CommandPoint 72XR5 and 72XR30 System Manual 15
Primex Wireless, Inc. – US Primex Wireless, Inc. – Canada Phone: 1-800-537-0464 Fax: 262-248-0061 Phone: 1-800-330-1459 Fax: 905-952-0134 Technical Support: 1-800-404-8112 Technical Support: 1-800-404-8112 Email: info@primexwireless.com Email: info@primexwireless.ca Website: www.primexwireless.com Website: www.primexwireless.ca Primex Wireless, Inc. ©2006, Patents Pending. Printed in the USA.