User's Manual

ManualsBrandsPrimatronix ManualsElectronicsRemote Controller of Navigation and Information Reference Point System

What’s Included for AC Power version

Base Unit with AC Power Cable

Activator / Charger / Power Supply

Wall Mounting Bracket / Screw Driver / Screws

User’s Guide

What’s Included for Solar Panel version

Base Unit

Solar Panel with Cable

Activator / Charger / Power Supply

Wall Mounting Bracket / Pole Bracket / Screw Driver / Screws

User’s Guide

Instruction Manual

Thank you for purchasing this unit, while using or installing it, please read this instruction

manual carefully.

Model:STEPHEAR

Summary of content (6 pages)

PAGE 1
Model:STEPHEAR What’s Included for AC Power version Base Unit with AC Power Cable Activator / Charger / Power Supply Wall Mounting Bracket / Screw Driver / Screws User’s Guide What’s Included for Solar Panel version Base Unit Solar Panel with Cable Activator / Charger / Power Supply Wall Mounting Bracket / Pole Bracket / Screw Driver / Screws User’s Guide Instruction Manual Thank you for purchasing this unit, while using or installing it, please read this instruction manual carefully.
PAGE 2
Location of controls 10 7 8 11 13 12 14 9 1 2 ACTIVATOR & CHARGER 3 16 4 5 6 BASE UNIT 1. AC cable for AC unit 2. LED indicator Message playing/White Battery low/Red Charging/Red Battery fully charged/Green 3. Speaker 4. Button 1 5. Button 2 6. Button 3 7. DC socket 8. Audio socket 9. Additional flash LED socket 10. Key 1 11. Key 2 12. LED indicator 13. Key 3 14. Power ON/OFF button 15. Charger 16.
PAGE 3
Wall mounting Your unit is suitable for wall mounting. Use two screws for fixing.
PAGE 4
BASE UNIT Connect the AC Power cable into an electric outlet socket. Recording message 1. Hold button 2&3 for 2 seconds at the same time to toggle recoding on/off, while the white LED flash once it means your recording is set to on and two times is off. 2. Press and hold button 1/2/3 and speak clearly when you hear a beep tone, the message can be up to 10 minute long. 3. Release the button 1/2/3, the base unit will play the recorded message automatically.
PAGE 5
ACTIVATOR Turn the activator On/Off To turn the activator ON, press and hold the POWER key on the activator for 2-4 seconds until a beep tone is heard. To turn the activator OFF, press and hold the POWER key for 2-4 seconds again, until two beep tones are heard. The red LED indicator will flash. Activator default set is beep & vibrate on. Turn the beep tone OFF 1. Press and hold the POWER key to turn on the activator. 2.
PAGE 6
External Flash and Buzzer: If message start playback by activator, the external white LED will flash and the buzzer will beep. Press the LENS button will stop the flash and the buzzer. FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules.