User's Manual

ManualsBrandsPrimatronix ManualsElectronicsNavigation and Information Reference Point System

Instruction Manual

Model: STEP-HEAR™

Location of controls

BASE UNIT ACTIVATOR & CHARGER

1. Socket for power jack

2. Record ON/OFF switch

3. Spare Socket for external

Flashing LED light

4. Flashing light/ battery low

indicator

5. Range Normal/Long switch

6. Speaker

7. Press and hold to record

message 1

8. Volume control switch

9. Press and hold to record

message 2

10. Microphone

11. Press to check message 1

12. Press to check message 2

13. LED indicator

14. Power ON/OFF button

15. Charger

Summary of content (5 pages)

PAGE 1
Instruction Manual Model: STEP-HEAR™ Location of controls BASE UNIT 1. 2. 3. 4. 5. 6. 7. Socket for power jack Record ON/OFF switch Spare Socket for external Flashing LED light Flashing light/ battery low indicator Range Normal/Long switch Speaker Press and hold to record message 1 ACTIVATOR & CHARGER 8. 9. 10. 11. 12. 13. 14. 15.
PAGE 2
Base Unit Connecting the AC Adaptor of the Base Unit 1. Plug the power cord of the AC adaptor into the jack labeled DC 9V on the back of the Unit (1). 2. Plug the other end of the power cord into an electric outlet. Fitting the batteries 1. 2. 3. 4. The battery compartment is to be found on the underside of base unit. Open the battery compartment with a small screwdriver or a pointed object. Insert 4 AAA 1.5V batteries. In doing so, ensure that the polarity is correct. Close the battery compartment.
PAGE 3
Please Note: Please set Record ON/OFF switch to OFF after recorded your message. Please Note: Operators need to understand that the quality of the recordings, the contents of the information provided and the locations of installation of the base units are critical to the successful use of the STEP-HEAR™ system. 1. Record messages in a quiet environment with no background noise or sound. 2. Carefully decide on number of strategic installation points of the base units at chosen areas. 3.
PAGE 4
1. Press and hold the POWER key (14) to turn on the activator. 2. Press and hold the activator 1 (11) and 2 (12) buttons together for 5 seconds until a beep tone is heard. The activator will only vibrate. 3. To turn the beep ON, press and hold the 1 and 2 buttons together again until you hear a beep tone. The activator will vibrate and beep. The activator keeps the latest settings until a new setting is received. Pause mode 1. Press the POWER key once to pause the vibrating and beeping.
PAGE 5
Warning: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.