Owner manual
InstructionSheet
Part No........................................................93008459
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information and
instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and
proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and during
servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed
by qualified service personnel. Product must be grounded to avoid potential electric shock or other
potential hazard. Product must be mounted in locations and at heights and in a manner consistent with
its intended use, and in compliance with the National Electrical Code and local building codes. The use
of accessory equipment not recommended by the manufacturer or installed contrary to instructions may cause an unsafe
condition. Do not block light emanating from product in whole or part, as this may cause an unsafe condition. Do not allow
items such as drapes, curtains, screens or the like to come into contact with the product or to block light from the product, as
this may cause an unsafe condition.
INSTALLATION INSTRUCTIONS
6C3, 6B3, 6L1, 6C3ST, 6B3ST REFLECTOR
www.prescolite.com Prescolite TollFree Technical Support 1.888.PRS.4TEC Hours: 8am - 5pm ET
A. Lamp Adjustment Prior
To Trim Installation:
1. Loosen horizontal and vertical locking
Thumbscrews as shown, (1) & (2).
2. Remove Lamp Holder (3). Install lamp into
Socket (4). Re-install Lamp Holder into
Lamp Mounting Plate (5).
3. Turn power on.
4. Rotate Lamp Adjusting Mechanism (6)
to desired vertical angle and horizontal
position by inserting a standard
screwdriver into slots as shown.(6)
NOTE: Vertical increment indicator
numbers can be used to pre-adjust
the vertical angle if desired.
B. Trim Installation:
1. Remove Screw (10), pull Safety Cable
(7) through opening in Plaster Frame and
attach to Trim as shown using screw (10).
2. Squeeze the two Torsion Springs (8)
together and insert ends into slots on both
Brackets (9) as shown.
3. Push Trim towards ceiling until the Torsion
Springs force the Trim against the ceiling
line.
C. Final Adjustment:
1. Make final vertical adjustment using
screwdriver as described above.
2. Make final horizontal adjustment by
holding outer flange on Trim and rotating
horizontally. NOTE: If necessary, pull
the flange away from the ceiling
slightly before rotating.
D. Locking Vertical and Horizontal Aim:
NOTE: Turn power off and allow
lamp to cool if necessary.
1. Pull Trim away from ceiling, reach into
housing and rotate two Thumb Screws (1)
& (2), clockwise to lock in place.
2. Push Trim back towards ceiling until seated
against ceiling.
CAUTION: DO NOT ATTEMPT TO MODIFY OR REWIRE FACTORY-INSTALLED WIRING ON THE FIXTURE. SAFETY
AND PROPER OPERATION OF THE FIXTURE DEPEND ON THE INTEGRITY OF THE WIRING.
701 Millenium Boulevard • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2007, 06/07, All Rights Reserved - Printed in U.S.A.
426&&;&5034*0/
413*/(4"44)08/
-0$"5&53*.'&"563&
"8":'30.4*%&8*5)
4"'&5:$"#-&
426&&;&413*/(50(&5)&3"4
4)08/"/%*/4&35*/4-054