PBS installation guide The iLocate Tracking Solutions PBS installation guide Copyright © 2007 Precyse Technologies Inc.
PBS installation guide Regulatory Information/disclaimers Installation and use of this Wireless Radio device must be in strict accordance with the instructions included in the user documentation provided with the product. Any changes or modifications made to this device that are not expressly approved by the manufacturer may void the user’s authority to operate the equipment.
PBS installation guide Table of contents Regulatory Information/disclaimers ............................................................................................. 2 Introduction ........................................................................................................................4 Acronyms ..................................................................................................................................... 4 Standards used throughout this guide ....................
PBS installation guide Introduction The PBS is a component of the Precyse iLocate™ real time location system. The PBS allows for 2-way RF communication with the Smart Agent tags, supporting multi-frequency mode for unexpected RF interference protection. The PBS base station is a low cost, low maintenance stand-alone device. This unit communicates with the central iLocate™ server over existing Ethernet or Wi-Fi networks.
PBS installation guide Theory of operation The PBS base station is responsible for synchronizing all the other parts of the system and transmitting data to and from the PC connected to it. The GPS receiver in the PBS is used as an absolute timing and clock source. Amplifier block: The amplifier box is connected to the PBS via a proprietary control protocol. Two of the four RF connectors are used as transmit and receive channels to the amplifier.
PBS installation guide Amplifier unit PBS connectors and indicators 1. Power indicator 2. Synch indicator 4 7. DC Power port 8. Heartbeat port 4 3 3 2 2 3-6. PBS channel indicators 1-4 1 1 9-12. TCP\IP ports 1-4 PBS - front view 6 Parelec Inc.
PBS installation guide 1 2 3 18. Synch Generator (GPS Antenna) 4 13-16. RF Channels antennae connectors 17. External amplifier connector PBS - rear view Connector / indicator Description 1. Power indicator LED (red) On - Power is connected. Flashing - There is a problem with the power supply. Off – power supply not connected. 2. Synch indicator 3-6.
PBS installation guide Connector / indicator 18. GPS Antenna connector Description Connect a GPS antenna (Either active or passive) PBS hardware installation Pre-installation checklist: 8 Determine the specific location for the PBS. Ensure available power source (AC). Available LAN port to connect to the iLocate ™ server. Antennae. Parelec Inc.
PBS installation guide Installation: 1. Connect the PBS to the power supply. Verify that the power indicator LED (#1) turns on. Warning: The power consumption of the unit is 12V-2.0A,. In order to ensure proper functioning of the unit, use the power source supplied with the unit or a compatible power unit with the same polarity and voltage. 2. Connect the antenna to the appropriate RF antenna connector. You can use only antennae by Precyse technologies. Other antenna types supported.
PBS installation guide PBS TX (J2) RF Transmit DB9 (J17) DB9 Cable RX (J3) RF receive TX (J1) RX (J2) DB9 (J4) Amplifier 10 Parelec Inc.
PBS installation guide Checking the installation Visual check after connection Verify that the power LED indicator (red) is on when the power is connected. Verify that the appropriate PBS RF Channel indicator is on. Verify that the Appropriate LAN LED indicator is on Check connection of PBS to the network / server ( ping ) . Appendix A: Marketing and installation 1. The product intended use and application: The BS24103000 (PBS) is used as a radio base station for the iLocate system.
PBS installation guide One Stamford Plaza, 263 Tresser Blvd Suite 957, Stamford, CT 06901 Tel: 203.564.1526 http://www.precysetech.com Parelec Inc.