Back-Up Sensor System Model No.: PKC0RE Owner’s Manual and Warranty Information OFF ON POWER 0.4m/1.3ft 0.6m/2.0ft 1.0m/3.3ft 1.2m/4.0ft 1.5m/5.0ft LEFT RIGHT Read these instructions completely before using this product. Retain this Owner’s Manual for future reference.
CONTENTS SAFETY PRECAUTIONS................................................................................................................. 2 Back-Up Sensor Safety............................................................................................................ 2 INTRODUCTION.............................................................................................................................. 2 FEATURES........................................................................................
FEATURES • Detects objects or people from approximately 5 ft (1.
INSTALLATION Some states or local governments may have regulations or laws that restrict the use of anything that might impair the clear view of a license plate. Check local laws for compliance. For the Back-Up Sensor to be properly installed, it must be wired into the vehicle’s taillight harness. If you are not comfortable or knowledgeable with 12-volt DC wiring, have the system professionally installed.
. 6. Determine which are the positive (+) and negative (-) wires for the reverse lights on the vehicle. You can use either the right- or left-side reverse light wires. For help locating the vehicle’s reverse light circuit, contact your vehicle’s manufacturer for vehicle-specific wiring diagrams. Remove the vehicle’s negative (-) battery cable. 1 2 7. 8. 9. 10. 11. 12. 13. 14. Legend 1. Wire from Vehicle 2.
NO FFO 30. Using a small piece of wire or paper clip, push the learn link button on the back of the receiver. 31. When a mutual frequency has been found, the receiver will beep twice. If a mutual frequency was not found, the red LEDs next to the “0.4m/1.3ft” on the receiver will flash, but the receiver will not beep. If this happens, switch the receiver off and back on and push the learn link button again to repeat the procedure. If a problem still persists, check the system installation. 1. 2.
SPECIFICATIONS 1. 2. 3. 4. 5. 6. 7. DC Input Voltage Controller Operation Current Receiver Operation Current Receiver Unobstructed Range Alarm Volume at 11.8 in. (30 cm) Away Frequency Working Temperature 10-16V ≤ 75mA ≤ 75mA ≥ 49 ft (15 m) ≥ 50dB 433.92 ± 0.2MHz 14°F to 113°F (-10°C to 45°C) FCC INFORMATION Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
TROUBLESHOOTING - continued Problem Situation Receiver and/or controller power LEDs do not illuminate when the vehicle is put into reverse Sensor system wires are loose or improperly connected Receiver always indicates an object behind the vehicle (green, yellow or red LEDs on) The sensors are mounted incorrectly or have moved Receiver power LED (green) illuminates but does not detect any obstacles Receiver does not indicate correct distances The sensors are covered with snow, mud, ice, etc.
