Wireless Parking Sensor Model No.: PDC320 Owner’s Manual 2 1 2 )) 32 :( 5 P IW P IW P IW P IW P IW /()7 5,*+ 7 Read these instructions completely before using this product. Retain this Owner’s Manual for future reference.
CONTENTS SAFETY PRECAUTIONS................................................................................................................ 2 Wireless Parking Sensor Safety.............................................................................................. 2 INTRODUCTION ............................................................................................................................. 2 FEATURES..............................................................................................
FEATURES x Detects objects or people from approximately 5 ft (1.
INSTALLATION Some states or local governments may have regulations or laws that restrict the use of anything that might impair the clear view of a license plate. Check local laws for compliance. For the Parking Sensor to be properly installed, it must be wired into the vehicle’s taillight harness. If you are not comfortable or knowledgeable with 12-volt DC wiring, have the system professionally installed. 1. 2. 3. 4. Remove the screws that hold the license plate to the vehicle.
. 6. Determine which are the positive (+) and negative (-) wires for the reverse lights on the vehicle. You can use either the right- or left-side reverse light wires. For help locating the vehicle’s reverse light circuit, contact your vehicle’s manufacturer for vehicle-specific wiring diagrams. Remove the vehicle’s negative (-) battery cable. 1 2 Legend 1. Wire from Vehicle 2. Wire from Controller 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24.
OPERATION 1. 2. While driving in reverse, a beep will sound and a green LED will light up when an object is 5 feet (1.5 m) away. If the object is more than 5 feet (1.5 m) away, there will be no sound and the LED will not light up. As you get closer to an object, the beeping speed will increase and additional LED lights will light up. When all LEDs are lit and the alarm is a constant sound, stop the vehicle immediately. Continuing in reverse may damage vehicle or wireless parking sensors. 3.
FCC INFORMATION Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
TROUBLESHOOTING - continued Problem Situation Action The sensors are mounted incorrectly or have moved The sensors may be located too low or pointed downward, therefore detecting the ground or other object. Check sensor location and alignment. Realign as necessary. The sensors are covered with snow, mud, ice, etc. Clean sensors.