WIRELESS BACK-UP CAMERA SYSTEM with 12cm / 4.
INTRODUCTION The Pro-User PKC0BU4 Tx is member of the family of advanced car back-up systems manufactured by Pro User International Ltd. The Pro-User Digital Back-up Camera and Monitor with built in transmitter box, when used as described, will improve your ability to see behind your car, camper, trailer, or mini-van. We have taken numerous measures in quality control to ensure that your product arrives in top condition, and will perform to your satisfaction.
INSTALLATION These instructions do not apply to all vehicles. They are only meant as a general guide due to the number of different makes & models. For vehicle specific questions contact your vehicle’s manufacturer. Camera installation There are several ways to mount the camera on the back of your car. But the most convenient is to mount it near the license plate of the car. Supplied is one mounting plate that can be fixed behind the license plate, and the mounting plate have been installed in the camera.
3. Mount the license plate on the license plate bracket. 4. Choose a routing path for the camera’s power cable through the vehicle’s body to the reverse light circuit. If in doubt, seek professional installation assistance. 5. Some vehicles may have a hole available to pass the wire through, such as where the license plate light is mounted, or you can drill a hole close to where the power cable is attached to the camera. Once you have chosen where the cable will enter the vehicle’s body, remove the camera.
13. Next splice the black wire of the camera power cable to the reverse light’s negative (-) wire or ground. 14. Replace the reverse light bulb, and then re-install the light socket. Secure all the wires with cable ties or electrical tape. 15. Re-attach the negative battery cable to the battery. Monitor Installation When choosing a location to mount the monitor, make sure the monitor is in an area that will not obstruct your vision while driving. 1.
OPERATION Please always pair the monitor and camera during the 1st operation, operation details please refer below step. The monitor will automatically turn on when the vehicle is in reverse gear. There are 5 control buttons available for users to have their controls: Menu button Power button Guideline button Power button Press the POWER button to supply power to the monitor. When the monitor image is on, the blue LED will be lit.
To change the orientation of the screen image, press the menu button until direction is selected. By pressing the or button repeatedly, different screen orientations will be available. These different views allow you to mount the camera and monitor in any position with keeping the right picture on the monitor. To exit the screen, press the menue button or it will automatically exit after 10s.