*** USER’S MANUAL *** FCC ID : RAC3861A01
The Federal Communication Commission Statement This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication. installation.
1. Installation 1.1 System Requirements This keyboard requires a PC with USB connection and one of the following operating systems: Windows 98SE / ME / 2000 / XP / Vista For the installation of the keyboard under the mentioned above operating systems you need NO special driver! 1.2 Installation of the USB receiver In order to install your keyboard, please perform the following steps: Connect the included USB receiver (dongle receiver) to a free USB port on your computer.
Switch the I/O sliding switch to ON position! Advice: The USB receiver and the keyboard are factory-made already synchronised on the same channel. Normally you have not to make a new-synchronisation (as described under point 2.4). The keyboard is immediately functioning. Now you can check the functionality by pressing any key of your keyboard. If you press the Windows key, there has to open for instance the Windows Pop-up menu down left on your screen.
In implausible case the keyboard does not work even after new-synchronisation, you have the following options to solve this problem: Repeat the procedure including the hardware reset of the USB receiver (conventional synchronisation) by pressing at first the LED key on the USB receiver (blue LED of the USB receiver flashes 3 times in a row) and only now the PAIRING key on the back side like mentioned above.
2.2 Special operation modes of the keyboard Sleep-Mode When 30 minutes happens no input in your keyboard respectively touchpad, the keyboard turns automatically into Sleep-Mode (idle state) to save battery capacity. Wake up-Mode For activating the keyboards from Sleep-Mode press any key on your keypad (not the left or right mouse function key of the touchpad or the touchpad itself!). Reconnect-Mode After reactivation the keyboard connects automatically again with the USB receiver.
