Wireless WorkSight® PreView® WWS7220 Operating Manual / Installation Guide Proudly developed by 10335 W. Emerald St. Boise, Idaho 83704 Phone 1.844.787.2327 (866) 977-7326 www.PreViewRadar.com Page 15 3700075A Copyright 2015 www.PreViewRadar.
(866) 977-7326 www.PreViewRadar.
FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
PreView® Configuration Options: Custom System Configurations – Thanks to the advanced engineering by the Preco Engineers, the technology behind PreView Sensors can easily integrate or control your vehicles existing or new safety systems. (866) 977-7326 www.PreViewRadar.
Warranty Information MANUFACTURER STANDARD LIMITED WARRANTY AND LIMITATION OF LIABILITY Manufacturer warrants that on the Date of Purchase this Product will conform to Manufacturer's published specifications for the product, which are available from Manufacturer on request, and Manufacturer warrants that the product is free from defects in materials and workmanship. This Limited Warranty for sensor extends for twenty four (24) months from the date of shipment.
Specifications SENSOR SPECIFICATIONS (Typical) Transmitter: Pulsed RF transmitter at 5.8GHz operating under FCC Part 15.249 Electronics: Solid state Connector: Deutsch DT06-08SA-E008 Sealing: Encapsulated to protect from dust and moisture, designed to meet IP67. Housing Material: Polycarbonate radome Dimensions: 4.4”H x 10.5"W x 1.4"D (11.2cm x 26.7cm x 3.6cm) Weight: 2.3 lb. (1.
Troubleshooting Sensor Description Display cannot find or connect to the wireless sensor: Verify that DC power (9-33V) is applied to the sensor. Sensor may be out of range. Contact Preco Electronics for assistance. “Not In Reverse” message is present, but machine is in reverse: Verify display and sensor are configured properly. For installation method A (see the display manual), verify reverse connection has 9-33V present.
Object Detection Capability The PreView® system is designed to supplement other safety practices and/or devices, it is not to be the sole method of collision avoidance. The machine operator is always the first line of defense when safely operating a vehicle. The Wireless WorkSight PreView system can detect most objects within the detection zone. However, there are some instances where objects can go undetected.
PreView® Daily Maintenance Detach this page and place with daily operator maintenance procedures. Safety Message to Operators of Vehicles with PreView Systems 1. 2. 3. 4. 5. 6. 7. The PreView system is intended as an Object Detection System and should not be relied upon as your first line of defense for the safe operation of the vehicle.
Sensor Power Connection Installation Instructions Before You Start Prior to installing the Wireless WorkSight PreView sensor, take time to familiarize yourself with the installation instructions, theory of operation, and system components. Check the contents of the shipping package and verify the following items are included: Though the sensor communicates wirelessly to the display unit, it still requires a wired connection to provide power and ground.