User's Manual

T4PR02-T2PR02
CAUTION FOR THE USER
Any change or modification of the product is forbidden if not expressly approved by
the manufacturer
GENERAL INFORMATION The T4PR02 4 channel and the T2PR02 2 channel transmitter transmits the rolling
security code at 433 MHz and is fitted with a remote self-learning function on the receiver. They are powered by a
lithium 3V battery (size CR2032).
Intended use of the equipment: radio transmitter in garage-door systems.
Typical use of the equipment: the equipment is not foreseen for continuous operations
ENTERING THE TRANSMITTER IN THE MEMORY OF THE RECEIVER
1. Press the programming button on the receiver; the red LED lights up.
2. Press the button corresponding to the transmitter channel to be memorised; the code is set in memory. During
the insertion, the receiver LED flashes for about two seconds, then returns to the steady light state to indicate that
a new transmitter can be entered.
When the operation is completed, press the programming button on the receiver again to exit from the procedure,
the LED goes out. The exit from the procedure is automatic after 10 seconds from the last insertion of a
transmitter.
REMOTE ENTERING OF NEW TRANSMITTERS IN THE MEMORY OF THE RECEIVER (RPA FUNCTION)
1. Approach the receiver (1-2m) with an already programmed transmitter.
2. Press buttons 1 & 2 at the same time then release them (fig. 1); the LED lights up and after about 2 seconds
goes out.
3. When the LED lights up again, press buttons 1 & 2 at the same time again and keep them pressed until the LED
starts flashing alternatively red-green.
4. At the end of flashing, the TX sends a transmission which activates the learning function of the receiver
5. The receiver waits 10 seconds for transmissions from new transmitters. Press one of the buttons of the
transmitter to be learned. The receiver stores the new transmitter into its memory.
6. During the learning procedure, the 10 seconds learning timeout is restored at any new transmitter learned.
HOW TO CUT OUT THE BATTERY SAVER FUNCTION
The battery saver function is activated after 3 seconds after the start of transmission: the LED flashes and the
transmitter ceases to transmit. In order to disable this function:
1. Press buttons 1 and 2 of the transmitter at the same time and release them: the LED turns on and after 2
seconds turns off.
2. When the LED turns on, press second button of the transmitter (fig. 2), and hold it until the LED starts flashing:
the battery saver function is now disabled.
3. Repeat the same procedure if you want to re-enable the battery saver function.