Installation Instructions

044-05080 Rev. A
ii
TABLE OF CONTENTS
Par. Section 1 Page
No. General Description No.
1-1 Introduction.............................................................................................................1-1
1-2 General Description................................................................................................1-1
1-3 Functional and Physical Specifications......................................................................1-1
Section 2
Installation
2-1 Introduction.............................................................................................................2-1
2-2 Electrical Service Recommendations.........................................................................2-1
2-3 Unpacking and Inspection ........................................................................................2-1
2-4 Installation Instructions ............................................................................................2-2
2-5 +26 VDC Power and Ground Connector P1................................................................2-2
2-6 Alarms and Sensing Connector P2............................................................................2-3
2-7 Differential IIC Clock, Receive, and Transmit Connector P3..........................................2-4
2-8 IIC, Power, Alarms,and Controls Connector P4...........................................................2-4
2-9 IIC, RS485, Power, and Other Signals Connector P5..................................................2-6
Section 3
Operating Instructions
3-1 Introduction.............................................................................................................3-1
3-2 Initial Start-Up and Operating Procedures ..................................................................3-1
Section 4
Principles of Operation
4-1 Introduction.............................................................................................................4-1
4-2 RF Input Signal .......................................................................................................4-1
4-3 RF Output Load.......................................................................................................4-1
4-4 Amplifier Functional Description................................................................................4-1
4-4.1 Input Amplifier.........................................................................................................4-1
4-4.2 Driver Amplifier........................................................................................................4-1
4-4.3 Main Amplifier.........................................................................................................4-2
4-4.4 Multifunction Board..................................................................................................4-2
4-5 Amplifier Module Cooling..........................................................................................4-2
4-5 Power Distribution ...................................................................................................4-2