User's Manual

Wireless
Home Appliance
Remote Control Kit
R9P-005
R9P-006
R9P-119
R9P-402
R9P-119
R9P-402
User’s Manual
All Versions
Operating Instruction - Outlet Adaptor
1. Plug the outlet adaptor into a powered 125VAC wall outlet.
2. Plug the fixture / appliances you wish to control into 1 outlet wall tap / wall
tap plus or the remote outlet of the yard stake.
3. Turn the mechanical power switch (electrical power switch is not
applicable) of the fixture / appliance to the ON position.
4. Use the remote control to turn ON/OFF the fixture/appliance (see the
operating instruction – remote control in below).
IMPORTANT:
● Outdoor use outlet adaptor is recommended plugged into a
GFCI-protected outlet.
● Outdoor use outlet adaptor is suitable for damp locations. Not for water
immersion or for use where directly exposed to water.
● Yard stake outlet adaptor should be installed above ground level so it will
not fill up with water when raining or snowing. Always unplug and remove
the devices from the yard stake when raining or snowing.
Operating Instruction – Wireless Remote Control
In open space, the remote control has a wireless range up to 100 feet* to
control the outlet adaptor.
*Actual range may vary depending on environment condition, interference
and building materials.
To turn ON and OFF the lighting fixture/appliance
1. To turn ON the lighting fixture/appliance, press ON switch on the remote
control. The red LED indicator on the remote
control will flash and the
lighting fixture/appliance on the outlet adaptor will turn ON.
INTRODUCTION
THANK YOU for purchasing Wireless Home Appliance Remote Control Kit,
you can remotely control indoor or outdoor fixtures and appliances from up to
100ft away (in open space).
Having your holiday lighting or appliances turned ON & OFF is just as easy as
few clicks on the remote control. Our product can conveniently help to
change your house into an easy home automation style.
OPERATING INSTRUCTIONS
NOTE: There are four types of Wireless Home Appliance Remote Control Kit
available that best suits your needs. The remote control and outlet adaptor
may vary depending on the kit model purchased.
Indoor Use
R9P-117
1-Outlet
Wall Tap with
remote control
1-Outlet
Wall Tap Plus
with remote
control
4-Outlets Yard Stake
(2 always on /
2 remote outlets)
with remote control
1-Outlet Wall Tap +
1-Outlet Wall Tap Plus
with 4 key remote control
R9P-118 R9P-402 R9P-109
Outdoor Use Indoor & Outdoor Use
Versions V1.0
2
Versions V1.0
1
Service Center in USA
Company’s name: Haowell Technology & Consulting, Inc.
Address: 415 Cloverdale Ln. Walnut, CA 91789-2028
phone no: 909-859-5150
Fax no: 909-468-4660
Contact person: Shannon Chang
E-mail: [e-mail]
© Copyright 2010
The information contained herein is subject to change without notice.
This document contains proprietary information, which is protected by copyright.
No part of this document may be photocopied, reproduced,
or translated into another language without the prior written consent.
February 2010
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user authority to operate the
equipment.
NOTE : This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
＊Reorient or relocate the receiving antenna.
＊Increase the separation between the equipment and receiver.
＊Connect the equipment into an outlet on a circuit different from that to which
the receiver is needed.
＊Consult the dealer or an experienced radio/TV technician for help.