Read these instructions before connecting and using your PowerBright™ Pure Sine Power Inverters. Failure in observing this warning may result in injury to persons and damage to equipment. General safety and installation information. Warning! The following fundamental safety measures must be observed when using electrical equipment to avoid danger of: - Electric shock - Fire - Injury About the unit itself - The inverter must only be used for the purpose specified by the manufacturer.
Required tools and installations equipment Depending on type of installation, the following tools are required: -set of screw drivers -drill and set of bits -wrench -crimping shears for the12/24V wire connection For connection of inverter to the battery, the following cable connecting hardware is needed: -2 different flexible cable connections.
Cables: Make sure to use the correct cables. A chart is provided below, for your reference: Max. Watt Output DC Amps Req’d Wire Gauge 150W 300W 600W 1000W 1500W 2200W 15A 30A 60A 100A 150A 220A #14 #10 #6 or 2 x #10 #2 or 2 x #6 #2 or 2 x #6 #2 or 2 x #6 Connection to the battery -Lay the flexible connecting cable (positive) and (negative) from the battery to the connecting terminals of the inverter (take cable cross section from the table). -Connect first the positive, then the negative cable.
! Reverse polarity connection of the battery wires can damage the inverter. Do not use the inverter with electrical systems using positive ground. Operation: 600W / 1000W / 1500 / 2200 pure sine wave inverter Power on: On the LED control “Power” lighting - Green LED. Over load: One the LED control “Over-Load” lighting-Red LED. Over temperature: On the LED control “Over-Temp” lighting-Red LED. Problem No output voltage, LED does not light Possible Cause 1. On/Off switch is not in the power ON position. 2.
Specifications: Model APS600-12 APS600-24 APS1000-12 APS1000-24 Continuous Power 600W 600W 1000W 1000W Surge 1000W 1000W 2000W 2000W Output Voltage 115V+/-3% 115V+/-3% 115V+/-3% 115V+/-3% Output Freq. 60Hz 60Hz 60Hz 60Hz Waveform Pure Sine Pure Sine Pure Sine Pure Sine Total Harmonic < 3% < 3% < 3% < 3% Input Voltage Range 10V-15V 20V-30V 10V-15V 20V-30V Efficiency > 85% > 85% > 85% > 85% No Load Current 0.85A 0.45A < 1.0 amp < 1.0 amp Low Battery Alarm 10.
Specifications: Model APS1500-12 APS1500-24 APS2200-12 APS2200-24 Continuous Power 1500W 1500W 2200W 2200W 1800W 1800W 2500W 2500W Surge 20 Minutes 3000W 3000W 3600W 3600W Output Voltage 115V+/-3% 115V+/-3% 115V+/-3% 115V+/-3% Output Freq. 60Hz 60Hz 60Hz 60Hz Waveform Pure Sine Pure Sine Pure Sine Pure Sine Total Harmonic < 3% < 3% < 3% < 3% 10V-15V 20V-30V 10V-15V 20V-30V Efficiency > 85% > 85% > 85% > 85% No Load Current < 1.0 amp < 1.0 amp < 1.