ADJ SUB-Woofer Control ILL INSTRUCTION MANUAL PWM-30M 6 BAND PARAMETRIC EQUALIZER
PWM-30M Content INTRODUCTION 1 INSTALLATION 2 electronic connections 3 location of the buttons 5 OPERATIONS 6 TROUBLESHOOTING 9 IMPORTANT INFORMATION Thank you for purchasing the PWM-30M6 band parametric equalizer. Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. BEFORE USE * For safety Do not raise the volume level too much, as this will block outside sounds, making driving dangerous.
INTRODUCTION FEATURES: 6 BAND PARAMETRIC EQUALIZER WITH 4 CHANNEL OUTPUT IN-DASH DIN SIZE: EASY COMPOUND WITH OTHER HEAD-UNIT TO A 2-DIN SIZE SYSTEM MOTORIZED HIDDEN ADJUST BUTTONS X-BREATH DUAL-COLOR INTELLECTIVE ILLUMINATION FRONT/REAR SEPARATE EQUALIZER ADJUSTMENT FRONT/REAR SEPARATE GAIN ADJUSTMENT SUB-WOOFER PRE-OUT & CONTROLLER (FREQ.
INSTALLATION The following illustration shows a typical installation. However, you should make adjustments corresponding to your specific car. If you have any questions or require information regarding installation kits, consult your car audio dealer or a company supplying kits.
ELECTRONIC CONNECTIONS 1 Typical Connections To the positive terminal of the car battery (bypassing the ignition switch) To metallic body or chassis of the car 3A fuse Yell ow LINE IN INPUT LEVEL 7V 0.
ELECTRONIC CONNECTIONS 2 If your head player provides RCA type line out, connect them to this unit's Line In socket. Li ne in If your head player does not provide RCA type line out, then disconnect the head player's speaker leads, connect them to this unit's High Level Input leads. Li ne in EQ EQ High Level Input CD/Casset te pl ayer Li ne out speake rs if any CD/Casset te pl ayer Note: Do not use this unit's low level and high level input together.
LOCATION OF THE BUTTONS 4 F1-L F2-L F3-L 3 F4 POWER R4 R1-L R2-L R3-L ON FRONT REAR SLEEP dB -15 LEVEL +15 -15 30-150 -15 +15 300-1.5K +15 Min GAIN 3K-15K Max Min GAIN Max -15 +15 -15 30-150 FREQ LEVEL +15 -15 300-1.
Operations 4 F1-L F2-L 3 F3-L POWER R1-L R2-L R3-L ON FRONT REAR SLEEP dB -15 LEVEL +15 -15 30-150 -15 +15 300-1.5K +15 Min GAIN 3K-15K Max Min GAIN Max -15 +15 -15 30-150 FREQ LEVEL +15 -15 300-1.
Operations The unit is in Power Off Status: Press the 2 (Illumination Switch) button, you can turn off the X-breath illumination. 4 Power Indicator When the unit turned on, the 3 (power indicator) indicator lights up. 5 Front Equalizer Level & Frequence Adjustment Adjust F1-L, F2-L, F3-L buttons to change the equalizer level of each band. Adjust F1-F, F2-F, F3-F buttons to change the equalizer center frequence of each band.
Operations F4 R4 POWER ON FRONT REAR SLEEP dB -15 LEVEL +15 -15 30-150 +15 -15 300-1.5K +15 Min GAIN 3K-15K Max Min GAIN Max -15 -15 30-150 FREQ LEVEL +15 +15 -15 300-1.
TROUBLESHOOTING What appears to be trouble is not always serious. Check the following points before calling a service center. Indication Symptoms Power Sleep LED LED Illumination Causes The unit dose not works at Off all. Off Off Off On Slowly Blue Sleep Glow mode On Off Off Incorrect gain setting On Off Off No input No sound from the speaker Remedies No power Check the fuse and supplied wiring to the battery. Check the connection and the +12volts power of REM.On.
SPECIFICATIONS AUDIO SECTION S/N Ratio (Rated Power, 1KHz) 100dB Distortion 0.01% Separation (Rated Power, 1KHz) 100dB FREQ. Response (1KHz=0dB, +/-2dB) 10Hz-35KHz RCA Input Level 0.7-7V RCA Input Impedance 20K 5V HI-Level Input Level HI-Level Input Impedance 100 Gain 20dB 7V Line Out Level (RMS.) 1K Line Out Impedance 6V SUB-WOOFER Output Level SUB-WOOFER Output Cut-off FREQ.
