User's Manual

ManualsBrandsPortman Security System International ManualsElectronicsRemote Control Transmitter

PORTMAN CAR ALARM

TRANSMITTER – 3-BUTTON

Button Functions Conditions

1 a. Arm and lock doors

b. Car finder with sound

c. Temporary stop alarm from sounding

d. Remote lock doors

Alarm is disarmed

Alarm is being armed

Alarm is sounding

While driving

2 a. Disarm

b. Remote unlock doors

c. Stop alarm from sounding

Alarm is being armed

While driving

Alarm is sounding

2 for 2 sec

Second unlock Alarm is disarmed

3 a. Silent arm

b. Car finder without sound

c. Anti car-hijacking

Alarm is disarmed

Alarm is being armed

While driving

3 for 2 sec Leave anti car-hijacking While in anti car-hijacking

1+2 Panic Anytime

2+3 Open trunk or Engine start Ignition is OFF

Remark: a. Please refer the above table and the following operating instructions

for all function.

b. Use Hopping code for transmission.

T40

FEATURES

CODE LEARNING

a. In disarm mode, turn ignition ON, press Valet Switch 10 times within 8

seconds, siren will chirp 3 times to enter code-learning mode.

b. Press any button on the transmitter within 8 seconds. If over 8 sec or turn

ignition OFF, the system will exit code-learning mode automatically.

c. The siren will chirp accordingly for confirmation as soon as the code is

learned. For example, the first transmitter is learned, the siren will chirp

once. The second transmitter is learned, the siren will chirp twice.

d. If one of the transmitters is to be programmed, the other transmitters must be

reprogrammed at the same time.

e. Up to 3 transmitters can be learned per module.

ARMING

a. Press button 1.

b. Siren will chirp once or no chirp (See Function Selection 6).

c. Parking light will flash once.

d. Door will be locked at 0.5sec or 3.5 sec (See Function Selection 1).

e. LED will flash slowly. If door is not closed, the siren will chirp 5 times for

warning and LED flashes quickly.

f. Disables engine starter if Interrupt (NC) Relay connected

g. After 3 seconds, the system is armed. All the sensors are armed. If the alarm

is triggered within 3 sec, the siren will chirp twice and the circuit is by-pass

till the triggering source is stable.

DISARMING

a . Press button 2.

b. Siren will chirp 3 times or has no chirp (See Function Selection 6). If siren

chirps 4 times, it means the alarm has been activated.

c. Parking lights will flash 3 times; if flash 4 times which indicates the alarm

has been activated. After flashing, the dome light will keep ON 30 sec max

or turn ignition ON the dome light is OFF.

d. Doors will unlock at 0.5sec or 3.5sec (See Function Selection 1).

e. LED is off and enables engine if Interrupt (NC) Relay connected.

SILENT ARMING

a. Press button 3.

b. Parking light will flash once.

c. Door will be locked at 0.5sec or 3.5 sec (See Function Selection 1).

d. LED will flash slowly. If door is not closed, the siren will chirp 5 times for

warning and LED flashes quickly.

e. Disables engine starter if Interrupt (NC) Relay connected.

f. After 3 seconds, the system is armed. All the sensors are armed. If the alarm

is triggered within 3 sec, the siren will chirp twice and the circuit is

bypassed till the triggering source is stable.

EMERGENCY DISARMING – OVERRIDE (FACTORY PRESET VALUE: PRESS

SWITCH 5 TIMES)

a . Turn ignition ON.

b. Press valet switch at set-up value (5 times), siren will chirp 4 times which

indicates the system is disarmed. This process must be finished within 8

seconds.

c. Replace Set-up Emergency Disarming value:

(a) Turn ignition ON. After press valet switch 5 times within 8 sec. Siren

chirp 4 times which indicates the system is in replace set-up mode

(b) Press the numbers (1-15max) as the value you prefer within 8 sec. (If the

number is over 15, the system will return back to the original set-up value)

Then, siren will chirp the numbers replaced for confirmation.

AUTOMATIC DOOR UNLOCK

When the ignition turn from ON to OFF, doors will be automatically unlocked.

AUTOMATIC DOOR LOCK (SEE FUNCTION SELECTION 4)

When the ignition turn from OFF to ON, doors will be locked after 20 sec.

VALET (S EE FUNCTION SELECTION 12)

a . In disarm mode, turn ignition ON, within 8 sec press and hold valet switch 3

sec once.

b. LED will be constantly ON after 8 sec or turn ignition OFF.

c. In Valet mode: siren chirp twice and parking lights flash twice.

d. Exit valet mode: Turn ignition ON, press and hold valet switch 3 sec once,

LED will be OFF after 8 seconds or turn ignition OFF.

e. In Valet mode, except arming function, the others remain the same.

PANIC

a Press button 1+2. The siren will sound, parking lights and dome light will

flash for 30 seconds.

b. Press any button to stop the panic.

CAR FINDER

a . The system is armed.

b. Press button 1 : siren will chirp once, parking lights and dome light will

flash 10 sec.

c. Press button 3 : car finder in silent mode, parking lights and dome light will

flash 10 sec.

d. Press button 2 to stop car finder and disarm.

ANTI CAR-HIJACKING (SEE FUNCTION SELECTION 7)

a. When ignition is ON and the doors are closed, press the button 3 and open

the door within 8 seconds to activate anti car-hijacking mode. If the door is

not opened within 8 sec, the mode is exit.

b. Close the door to start the 30 seconds countdown. The LED flashes quickly.

c. When the 30 sec is up, siren will chirp every 2 sec. After 20 seconds, siren

continuously, also parking lights will continuously flash. Siren will stop to

sound & parking lights will stop to flash as long as the ignition turn OFF.

After ignition is OFF, engine disables to start again (if interrupt (NC) relay

connected).

d. Disarm the anti car-hijacking: Press button 3 for two seconds. The parking

lights will flash once for confirmation.

2-S TAGE SHOCK SENSOR

a . If car is lightly vibrated once, siren will sound for 5 chirps. If the car is

vibrated again within 8 seconds, siren will sound and parking lights, dome

light flash for 30 seconds.

b. If car receives a heavy shock, siren will sound for 30 seconds and parking

lights, dome light will flash for 30 seconds

OPEN TRUNK OR ENGINE STARTER

a. Press 2+3 (with 0.5 sec 300mA negative output) to open trunk or connect to

engine starter module to start engine.

b. The trunk trigger, current sensor, shock sensor are bypassed till the trunk is

closed. After 4 sec, the system is in arm mode again.

DOOR LOCK CONTROL

a . While driving: press button 1 to lock doors. The doors can be locked.

b. Press button 2 to unlock doors. The doors can be unlocked.

AUTOMATIC REARMING (S EE FUNCTION SELECTION 10)

After disarming, the system will be re-armed automatically or re-armed with

door lock (See Function 11) after 30 sec if the ignition is not turned ON or the

door is not opened.

LAST DOOR ARMING (S EE FUNCTION SELECTION 8)

a. Turn ignition OFF and close the last door. After 30sec, the system will arm

automatically or arm with door lock automatically (See Function Selection 9)

or arm with ACC/FULL (See Function Selection 16)

b. If one of the doors is opened during the above 30sec, the system will

postpone the arming till the last door is closed.

MEMORY FUNCTION

The alarm will memory the condition although the power is cut off.

OTHER TRIGGER SENSOR

Other trigger sensor can be added which input is negative signal.

DISABLE ENGINE STARTER

Summary of content (2 pages)

PAGE 1
PORTMAN CAR ALARM TRANSMITTER – 3-BUTTON b. Button Functions 1 a. Arm and lock doors b. Car finder with sound c. Temporary stop alarm from sounding d. Remote lock doors a. Disarm b. Remote unlock doors c. Stop alarm from sounding Second unlock a. Silent arm b. Car finder without sound c.
PAGE 2
When arm, there’s a 300mA negative output to disable engine, which has to be connected a NC relay AUTO RE-ARM ( SEE SELECTION 10) Siren sounds 30 sec upon triggering. Then, the system goes back arming again. AUTO ARM AFTER TRIGERRING Siren sounds 30 sec upon triggering. Then, the system will return arming mode again. If the triggering signal exists still, the system will bypass this zone till it returns to normal status.