User's Manual

ManualsBrandsPorta Phone ManualsElectronicsComSTAR Xtreme

Page 1

Full Deplex Communication System

user manual

Introduction

Thank you for your choice of XTreme Communication System.

XTreme is a DECT (Digital Enhanced Cordless Telecommunications) Full Deplex Communication System. To

the quality of audio and to the safety offered from the digital technology, XTreme offers manifold and useful

features including Full duplex system, LED In use illumination, multi-headset capabilities and multi-volume select.

Please read this instruction carefully before using your new XTreme for the first time.

A glance guide for the headset

A glance guide for the base unit

A channel indicator (GREEN LED)

Vol up

Vol down

Talk/ Power on/off

Receiver

Mic

MicMute/CH

B channel indicator (RED LED)

Connector for Cord Headset

All Conference

Summary of content (6 pages)

PAGE 1
Full Deplex Communication System user manual Introduction Thank you for your choice of XTreme Communication System. XTreme is a DECT (Digital Enhanced Cordless Telecommunications) Full Deplex Communication System. To the quality of audio and to the safety offered from the digital technology, XTreme offers manifold and useful features including Full duplex system, LED In use illumination, multi-headset capabilities and multi-volume select.
PAGE 2
Installation Please check your package that included the following items: -Base Unit (Flx2000/PRO2000) -Wireless Headset (XTreme) -AC / DC adaptor for Base Unit - Base packing batterie - Headset packing batterie Choose a suitable site for the base unit, make sure it is not near to other electrical equipments. Connect the AC adaptor socket to the Base Unit and to your room’s power socket. Turn on the power of base. Power on/off Charging indicator And low battery indicator 6.0v-7.
PAGE 3
Make a talk -Power up the headset, the “In use” LED is ON. During a talk conversation, you can adjust the talk volume (1 ~ 5 levels) by simply pressing • or ‚ key. End a call -Press and hold“Talk” key, the “In use” LED is OFF. Mute -During a call conversation, you can mute your voice by pressing “Mute/CH” key, the headset will show mutetone that you can talk freely without be heard by the talk party, and you still be able to hear the talk party. -Deactivate the mute function, press “Mute/CH” again.
PAGE 4
-Press and hold SUB key enter the base’s registration mode with the “SUB” LED is ON -Press and hold SUB key again until the “SUB” LED is OFF -All headsets registered to this part are cleared Note: (1)SUB key A1orA2 to unsubscribe both A1 and A2. (2)SUB key A3orA4 to unsubscribe both A3 and A4. (3)SUB key B1orB2 to unsubscribe both B1 and B2. (4)SUB key B3orB4 to unsubscribe both B3 and B4. Conference talk When you are in a talk on the base, you can invite another channel headset to join your conversation.
PAGE 5
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 6
These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population. The guidelines are based on the safety standards previously set by both U.S. and international standards bodies. These standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.