Introduction Thank you for your choice of FULL DUPLEX WIRELESS COMMUNICATION SYSTEM. (Base Unit: FLX2000/ Wireless Headset :ComStar S) This is a DECT (Digital Enhanced Cordless Telecommunications) walkphone. To the quality of audio and to the safety offered from the digital technology, FLX2000/ComStar S offers manifold and useful features including Full duplex system, LED In use illumination, multi-headset capabilities and multi-volume select.
User manual contents Introduction ------------------------------------------------------------------------------------------------------------------------------------- 2 Contents in your package---------------------------------------------------------------------------------------------------------------------- 2 User manual contents--------------------------------------------------------------------------------------------------------------------------- 3 FCC Statement -------------------------------------
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help.
Registration indicator (RED LED) < Register > Bottom button: -press and hold to enter to the base registration mode. Installation Choose a suitable site for the base unit; make sure it is not near to other electrical equipments. Connect the AC adaptor socket to the Base Unit and to your room’s power socket. Turn on the power of base. Power on/off Charging indicator And low battery indicator 6.0v-7.5v battery pack AC Adapter socket Fitting the battery in the headset: 3.
Before using the headset, charge the headset for at least 6 hours. For base 6.0V rechargeable battery pack For headset 3.7V rechargeable battery pack Charger cradle Whenever you see the low battery indicator LED flash on the headset, or you have heard the low battery warning tones during a call conversation, please: -End the call as soon as possible. -Change the headset battery. To charge the battery, put the battery into the charger cradle.
standby mode. Out of range indication If your headset has registered and is in located range, the “In use” LED will blanking steadily, when your headset goes out of range, the communication link will be lose temporarily, the “In use” LED will blink. If you go back to the located range again, the communication link will restore, also the “In use” LED will blanking steadily. Note: your talk will be cut without any audible warning tone if you are in a talk and out of the located range.
-Press the “All Conference” key on the base once again, turn off the all conference mode. Specification Standard Frequency Frequency Channel Bandwidth Modulation type Transmission speed Duplexing Speech encoding RF Accessing Channel Coverage range Base Power Supply Headset Power Supply Charge Time initially Operation time Normal condition of use Storage Temperature DECT6.0 (Digital Enhanced Cordless Telecommunications) 1920 ~1930GHz (USA) 1880 ~1900GHz (EURO) 1.728 MHz GFSK 1.