Instructions / Assembly

1/4-20 X 2-1/4 WAFER SHCS

5/16 PLASTIC PINS

Tools Needed

4mm T Handle Hex Key -

included

Screwdriver

(1) Back

Model: NS48

Layout Parts

Layout Hardware

QTY

(2) Sideframes

(1) Seat

HARDWARE IS STAINLESS STEEL

UNLESS OTHERWISE SPECIFIED

12/13/2012

PG 1 OF 3

ASSEMBLY INSTRUCTIONS

5/16 X 3/4 OD FLAT WASHER

5/16-18 HEX NUT SS

.307 X 2-1/2 X 3/4 S-HOOK ZN

SNAP HOOK 1/4"

5FT ZINC CHAIN

5/16-18 X 4-1/4 EYE BOLT SS

5/16-18 X 5 EYE BOLT SS

PAGE 1
PG 1 OF 3 Model: NS48 Tools Needed Layout Parts (1) Seat (1) Back (2) Sideframes QTY 4mm T Handle Hex Key - included Screwdriver Layout Hardware 1/4-20 X 2-1/4 WAFER SHCS 4 5/16-18 X 4-1/4 EYE BOLT SS 2 5/16-18 X 5 EYE BOLT SS 2 4 5/16 X 3/4 OD FLAT WASHER 4 5/16-18 HEX NUT SS 2 5/16 PLASTIC PINS 2 .
PAGE 2
Swing Assembly 1 Attach the side frames using (2) 2¼" bolts and (2) 4¼" eyebolts with nuts and washers 2 Insert pins into back assembly 3 Attach the seat using (2) 5" eyebolts with nuts and washers Then, push seat into pins and attach using (2) 2¼" bolts *Note: Prep eyebolt with nut and washer Take nut to end of thread.
PAGE 3
4 Hang the swing Tip: hanging mounts should be about 55" apart Adjust this chain for height (9ft porch max) Adjust this chain for comfort S-hook Note: once comfort is set, S-hook can be closed with tool Snap hooks Tip: Seat should measure about 18" from floor pg 3 of 3