User's Manual

ManualsBrandsPolymap Wireless ManualsElectronicsBluetooth Remote

Version 1.1 – May 2005

Doc # 2520 Polymap Wireless Confidential and Proprietary.

PWR-07-03 Remote module

May 20, 2005

Introduction:

The PWR-07-03 provides a simple way for a LifeScan OneTouch Ultra device to

transmit its data via Bluetooth

connectivity. When a measurement is taken on the

OneTouch, this module automatically retrieves the measurement and tries to transmit it to

a receiving station. Should that station be unavailable, it will periodically retry the

transmission, and eventually shut itself down again.

Connection

The device is connected to the OneTouch Ultra through a phono jack. To set up the

device for the first time, please follow these steps:

Figure 1: positioning of PWR-07-03 device. Please note that cable must pass through mesh, which may

need to have a ¼” cut made in it near the bottom left corner.

1) Thread the phono jack through the mesh of the OneTouch Ultra case. You may

have to cut a ¼” slit to do this (please see figure above).

Summary of content (4 pages)

PAGE 1
Version 1.1 – May 2005 PWR-07-03 Remote module May 20, 2005 Introduction: The PWR-07-03 provides a simple way for a LifeScan OneTouch Ultra device to transmit its data via Bluetooth® connectivity. When a measurement is taken on the OneTouch, this module automatically retrieves the measurement and tries to transmit it to a receiving station. Should that station be unavailable, it will periodically retry the transmission, and eventually shut itself down again.
PAGE 2
Version 1.1 – May 2005 2) Plug the jack into the bottom of the OneTouch Ultra unit, being careful to press the connector firmly in place 3) Insert the 28L battery into the module. Please observe correct polarity or the device will not function correctly. 4) Close the zippered case. The module is ready to use. Appearance: Figure 2: PWR-07-03 with its battery. Usage Take a measurement as you normally would.
PAGE 3
Version 1.1 – May 2005 Figure 3: Indicator light shows through mesh Battery warning The module is currently designed to be connected to a OneTouch Ultra. If you disconnect it, by removing the meter from its case, please also remove the battery from the PWR-07-03 module to avoid draining it unnecessarily. If the module is left on the shelf with a battery in it, disconnected from the Ultra meter, it will rapidly exhaust its battery.
PAGE 4
Version 1.1 – May 2005 Polymap Wireless 310 S. Williams Blvd. Ste. 346 Tucson, AZ 85711 (520) 747-1811 PWR-07-03-OA FCC ID: QYPPWR0703 We declare under our sole responsibility that the product Polymap Wireless Remote PWR-07-01 complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.