User's Manual

USER'S MANUAL

Model Number: RC3A1

HOW TO USE THE REMOTE CONTROLLER:

The remote control is for the wired controller only:

(1) REMOVE THE BATTERY LID AT THE BACK OF REMOTE CONTROL, INSTALL THE TWO AAA/UM4/LR03

BATTERIES( NOTINCLUDED) PROPERLY AS INDICATED ON THE BATTERY COMPARTMENT. MAKE SURE

TO MATCH THE (+) AND (-) ENDS OF THE BATTERIES.

(2) PRESS THE BUTTON TO SELECT DIFFERENT FUNCTIONS, REFER TO “HOW TO USE THE DUAL COLOR

LIGHT CONTROLLER”.

(3) TO REPLACE THE BATTERY, OPEN THE BATTERY COMPARTMENT WITH A COIN. REPLACE WITH

TWO AAA/UM4/LR03 BATTERIES.

(4) DISPOSE USED BATTERY PROPERLY. OBSERVE LOCAL REGULATIONS REGARDING DISPOSAL OF

HAZARDOUS WASTE.

(5) ENSURE THE BATTERIES ARE INSTALLED CORRECTLY WITH REGARD TO POLARITY (+ AND -).

BATTERY REPLACEMENT

IMPORTANT SAFETY INSTRUCTIONS

• WARNING: SMALL PARTS, KEEP AWAY FROM CHILDREN.

• Do not expose light set to moisture.

• Do not mix old and new batteries.

• Do not mix alkaline, standard (Carbon - Zinc), lithium, or rechargeable (NiCd, NiMH or other type)

batteries.

• Remove batteries when not used for an extended period of time, or when depleted.

• Dispose of used batteries properly.

• Use only AAA-size (UM4/LR03) batteries for the remote controller.

• Clean the battery contacts prior to battery installation.

• DO NOT DISPOSE OF BATTERIES IN FIRE. BATTERIES MAY EXPLODE OR LEAK.

PAGE 1
USER'S MANUAL Model Number: RC3A1 HOW TO USE THE REMOTE CONTROLLER: The remote control is for the wired controller only: (1) REMOVE THE BATTERY LID AT THE BACK OF REMOTE CONTROL, INSTALL THE TWO AAA/UM4/LR03 BATTERIES( NOTINCLUDED) PROPERLY AS INDICATED ON THE BATTERY COMPARTMENT. MAKE SURE TO MATCH THE (+) AND (-) ENDS OF THE BATTERIES. (2) PRESS THE BUTTON TO SELECT DIFFERENT FUNCTIONS, REFER TO “HOW TO USE THE DUAL COLOR LIGHT CONTROLLER”.
PAGE 2
FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.