ULW-16 System User Manual

11
5. Once you have determined that the transmission quality and level are good, mount the
receiver.
Note: When holding the ULW-16-HHT handheld transmitter, hold it in the middle of the
transmitter body, not at the end where the antenna is located. Covering the antenna with
your hand will degrade the transmission quality.
MOUNTING
Once you have determined that the transmission quality and level are good, mount the receiver and transmitter.
Receiver
1. Loosen the receiver’s locking wheel and slide the mounting foot all the way into your camera’s
shoe. Make sure to position the receiver so the antenna doesn’t enter your image frame.
2. Tighten the locking wheel until secure.
3. If your camera has an XLR line-level input, use the included line-level output cable to
connect to your camera.
If your camera has a 1/8″ microphone input, use the included line-to-mic attenuator
to connect to your camera.