ULW-16 System User Manual

10
To select the channel on the ULW-16-HHT, follow these steps:
a. Remove the battery compartment cover.
b. Press and hold the SELECT button. The channel indicator on the LCD
display will begin to blink.
c. Change the channel with short presses of the SELECT button until the
desired channel is selected. The channel indicator will continue to blink for
10 seconds and then stop indicating that the channel has been selected.
d. Replace the battery compartment cover.
Note: If you are using multiple ULW-16 or ULW-16-HL wireless systems, make sure each system is set to a different channel—at
least three channels apart as a guard band.
3. With the headphone volume set to a low level, plug an earpiece or headphones into the receiver and gradually raise the level to
a comfortable volume for monitoring the transmission.
4. Adjust the audio output level on the receiver or the input level on your input device as necessary to make sure a sufcient level
is being recorded. The objective is to transmit the highest possible level without distortion for the best signal-to-noise ratio
throughout the signal path.
Important: It is not recommended to adjust the gain setting of the handheld transmitter. The gain is factory preset to the ideal
setting. Any volume adjustments should be made on the receiver or on the input device.