Installation Instructions

ManualsBrandsPolaris Industries ManualsElectronicswireless remote

Table Of Contents

Wireless Remote Kit
- OPERATIONAL CHECK

APPLICATION

Verify accessory fitment at Polaris.com.

IMPORTANT

This Wireless Remote Kit is intended for use with HD

4500 Lb. Winch Kit (PN 2882714).

BEFORE YOU BEGIN

Read these instructions and check to be sure all parts and tools are accounted for. Please retain these

installation instructions for future reference and parts ordering information.

KIT CONTENTS

This Kit includes:

REF QTY PART DESCRIPTION PART NUMBER

1 1 Receiver, Wireless

2 4

Screw, Torx

Pan Head, High/Low - #14 X 0.75 7519731

3 1 Remote, Wireless

4 1 Holder, Wireless Remote

5 2 Screw, Torx

Pan Head, High/Low - #10 X 0.75 7512026

1 Instructions 9929286

Instr 9929286 Rev 01 2018-04 Page 1 of 5

P/N 2883455

WIRELESS REMOTE KIT

Summary of content (6 pages)

PAGE 1
WIRELESS REMOTE KIT P/N 2883455 APPLICATION Verify accessory fitment at Polaris.com. IMPORTANT This Wireless Remote Kit is intended for use with HD 4500 Lb. Winch Kit (PN 2882714). BEFORE YOU BEGIN Read these instructions and check to be sure all parts and tools are accounted for. Please retain these installation instructions for future reference and parts ordering information.
PAGE 2
TOOLS REQUIRED • Safety Glasses • Screwdriver Set, Torx® • Drill • Socket Set, Metric • Drill Bit: 1/8 inch (3 mm) • Wrench Set, Metric • Pliers, Push Pin Rivet IMPORTANT Your Wireless Remote Kit is exclusively designed for your vehicle. Please read the installation instructions thoroughly before beginning. Installation is easier if the vehicle is clean and free of debris. For your safety, and to ensure a satisfactory installation, perform all installation steps correctly in the sequence shown.
PAGE 3
INSTALLATION INSTRUCTIONS 1. Shift vehicle transmission into “PARK”. Turn ignition key to “OFF” position and remove from ignition switch. 2. Flip up passenger seat bottom, remove driver’s seat and underseat storage compartment, then disconnect black negative (-) cable from battery. 3. Gain access. a. Remove hood. b. Remove upper dash cupholder by removing two push pin rivets A, then sliding cupholder rearward. Retain rivets. c.
PAGE 4
OPERATION OPERATIONAL CHECK Wireless remote allows winch operation from outside the vehicle. If winch does not operate as described, refer to the TROUBLESHOOTING section. IMPORTANT The winch operator is always responsible for using the winch properly, as described in the “Winch User Guide” included in the winch kit. 1. To turn wireless remote “ON”, depress and hold power button for three seconds or until LED light illuminates. 2. To extend rope, depress and hold the “OUT” button.
PAGE 5
TROUBLESHOOTING SYMPTOM POSSIBLE CAUSES RECOMMENDED SOLUTION Dead vehicle battery Incorrect, damaged, or corroded electrical connections Verify all winch electrical connections are per instruction manual and free of damage and/or corrosion. Winch will not operate Contactor not receiving power Turn vehicle key on. Wireless remote not powered on Turn wireless remote on.
PAGE 6
FCC Statement: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.