BT50 Luxx Installation Manual Please read this manual before installing this product.
Warranty details Thank you for purchasing the BT50Luxx Before installing, be sure to thoroughly read these instructions. Warranty for this product is 2 years from date of purchase, however warranty will be void if: • The unit is tampered with, damaged or modified in anyway. • Reverse camera cable is cut or modified in any way (If applicable). • Reverse camera is subjected to over voltage (if applicable).
Installation Notes The wiring and installation of this unit requires special technical skill and experience. If you do not feel confident installing this product or do not have the level of skill necessary, please contact Polaris on 1300 555 514 so we can refer to a recommended installer. This unit is designed to be used in a vehicle with a 12 volt battery and a negative grounding.
Removing your panel 1. Use trim tool to remove air con control panel 4. Use trim tool to remove fascia panel 7. Remove 2 screws holding OEM screen in place 10. Unplug harness and set CD housing aside 2. Pull Air conditioning panel out. 3. Unplug harness and set air con panel aside 5. Gently pull fascia out 6. Unplug button panel and set aside 8. Unplug harness and set screen aside 9.
Wiring Diagram Important: Please see page 9 for information about replacing OEM Navigation systems Other wiring • Hazard Switch extension cable • 2 x USB retention adaptors > plug these into the cabled USB’s to retain your glove box USB and one USB in your panel (if required). • External Bluetooth microphone: unit does have internal microphone but you can run the external microphone if you like.
Wiring Diagram: Reverse Camera DIAGRAM 1 CONSTANT CAMERA AND TRIGGER Head REVERSE TRIGGER WIRE Acc+ CUT AND TAPE OFF WIRES AS NOT NEEDED IN THIS SET UP REVERSE FOUND IN ORIGINAL HARNESS (COLOUR MIGHT DIFFER FROM BRANDS AND MODELS) RCA PLUGS INTO CAMERA INPUT FOUND ON HEAD UNIT DIAGRAM 2 RCA CAMERA WITH REVERSE TRIGGER ONLY Head REVERSE TRIGGER WIRE POWER FROM REVERSE LIGHTS RCA PLUGS INTO CAMERA INPUT FOUND ON HEAD UNIT
Wiring Diagram: Reverse Camera (cont.
Prepare the fascia 1. Remove clips from original fascia panel... 2.
BT50 with OEM navigation IMPORTANT: If your BT50 had factory navigation in it, you will need to bypass the module for Accessories power: Tap into this wire with Accessories + power IMPORTANT: If your BT50 had factory navigation in it, please use the BLACK antenna connection that was originally plugged into the back of the OEM screen (not the CD Housing). Install the new head unit and fascia 1.