User's Manual

ManualsBrandsPoint Six ManualsElectronics15.231 (e) Wireless Weather Station Transmitter

FCC ID: M5ZWOW

Installation and Operation Instructions for the Wireless Temperature Sensor.

Point Six, Inc.

Wireless Temperature Sensor

Model WOW

Installation and Operation Instructions

The WOW wireless temperature sensor transmits both a digital temperature and a unique serial

number to a 418 MHz receiver. The WOW is enclosed in a high impact ABS enclosure for

direct surface mounting in the environment to be measured. WOW is battery operated

Application: Apply the sensor to the surface to be monitored with double-sided adhesive tape.

Make sure that the side labeled with FCC ID is visible and away from any metal surfaces.

Service Function: The wireless temperature sensor has an installation mode switch. A

momentary push of this switch will start the convert/transmit cycles. When new and until this

button is pushed the WOW will not transmit. The WOW will transmit a special installation

status mark in the data packet immediately after the installation/start switch is pushed. After the

start a push of the installation switch will result in the immediate transmission of temperature, ID

and installation status mark.

Battery: A 3.0-3.6 Volt lithium battery powers the WOW wireless temperature sensor. The

battery will last for more than 10 years in the idle state (as shipped from the manufacturer). The

WOW will transmit data for as long as 7 years at a rate of once each minute once started. The

WOW is completely covered with a water resistant rubber coating to protect the electronics from

the environment and condensation. The user cannot replace the battery. The WOW may be

placed in a quiescent state (battery life greater than 10 years) by holding the installation switch

closed for more than 12 seconds.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES, OPERATION IS

SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY

NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT

ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY

CAUSE UNDESERED OPERATION

FCC ID: M5ZWOW

MADE IN USA

Summary of content (4 pages)

PAGE 1
FCC ID: M5ZWOW Installation and Operation Instructions for the Wireless Temperature Sensor. Point Six, Inc. Wireless Temperature Sensor Model WOW Installation and Operation Instructions The WOW wireless temperature sensor transmits both a digital temperature and a unique serial number to a 418 MHz receiver. The WOW is enclosed in a high impact ABS enclosure for direct surface mounting in the environment to be measured.
PAGE 2
Wireless Temperature Sensor Data Format The Point Six, Inc. 418 MHz wireless temperature transmitters require a compatible receiver with the ability to receive, error check and provide RS232 and RS422/485 interface. This document describes the data format provided by the HA8-wow 418 MHz. Receiver.
PAGE 3
Example: D4287F44040000005A01602ED477 This field is the mode indicator, the LS-bit which indicates the service state of the transmitter, 0=normal, 1=service mode. D4287F44040000005A01602ED477 This field is the unique serial number of the 1-Wire temperature sensor. D4287F44040000005A01602ED477 This is the temperature data field; two's compliment 16-bit data stored MSB first in 1/16 deg. C units. The value shown is +22 Deg. C.
PAGE 4
FCC Radio Frequency Interference Statement Wireless Temperature Sensor FCC ID: M5ZWOW NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15, Subpart B, of the FCC Rules. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause interference to radio communications.