User's Manual

ManualsBrandsPoint Six ManualsElectronicsWireless Temperature Probe

FCC ID: M5ZPRO1

Installation and Operation Instructions for the Wireless Temperature Probe,

Model WOW-PRO.

Point Six, Inc.

Wireless Temperature Sensor Probe

Model WOW-PRO1

Installation and Operation Instructions

The WOW-PRO1 wireless temperature sensor transmits both a digital temperature and a

unique serial number to a 418 MHz receiver. The WOW is enclosed in a 304 stainless

steel tube enclosure for direct food penetration in the environment to be measured.

WOW-PRO1 is battery operated.

Application: Apply the sensor to the food object by penetrating the food to be

monitored with the pointed end of the tube. Make sure that the penetration is at least 1

inch past the tapered point.

Service Function: The wireless temperature sensor probe has an installation mode

switch. A momentary magnetic reed switch will start the convert/transmit cycles. When

new and until this is feature is activated the WOWPRO1 will not transmit. The

WOWPRO1 will transmit a special installation status mark in the data packet

immediately after the installation/start switch is activated. After the start further

activations of the installation switch will result in the immediate transmission of

temperature, ID and installation status mark.

Battery: A 3.0-3.6 Volt lithium battery powers the WOWPRO1 wireless temperature

sensor probe. The battery will last for more than 10 years in the idle state (as shipped

from the manufacturer). The WOWPRO1 will transmit data for as long as 10 years at a

rate of once each minute once started. The WOW is completely enclosed in 304 stainless

steel tupe. The user cannot replace the battery. The WOWPRO1 may be placed in a

quiescent state (battery life greater than 10 years and no transmissions) by holding a

magnet at the base of the antenna between the 304 stainless steel tube and the SMA

connector for more than 5 seconds.

Summary of content (4 pages)

PAGE 1
FCC ID: M5ZPRO1 Installation and Operation Instructions for the Wireless Temperature Probe, Model WOW-PRO. Point Six, Inc. Wireless Temperature Sensor Probe Model WOW-PRO1 Installation and Operation Instructions The WOW-PRO1 wireless temperature sensor transmits both a digital temperature and a unique serial number to a 418 MHz receiver. The WOW is enclosed in a 304 stainless steel tube enclosure for direct food penetration in the environment to be measured. WOW-PRO1 is battery operated.
PAGE 2
The Point Six, Inc. 418 MHz wireless temperature transmitters require a compatible receiver with the ability to receive, error check and provide RS232 and RS422/485 interface. This document describes the data format provided by the HA8-WOW, HA9WOW or HA10-WOW 418 MHz. Receivers.
PAGE 3
D4287F44040000005A01602ED477 This is the temperature data field; two's compliment 16-bit data stored MSB first in 1/16 deg. C units. The value shown is +22 Deg. C. D4287F44040000005A01602ED477 This field is the CRC-16 error check as was originally received and checked. This CRC is over the first 11 bytes of the packet starting with the mode flags and ending with inclusion of the temperature data.
PAGE 4
FCC Radio Frequency Interference Statement Wireless Temperature Sensor FCC ID: M5ZPRO1 NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15, Subpart B, of the FCC Rules. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause interference to radio communications.