User Manual

ManualsBrandsPoint Six ManualsElectronicsCounter/Sensor

Table Of Contents

Point Six, Inc. – 391 Codell Drive - Lexington, KY – 40509 - http://www.pointsix.com - 859-266-3606 – Fax: 859-266-0702

FCC ID: M5ZP6EZIO

Installation and Operation Instructions for the Analog/Counter Wireless transmitter P6EZIO .

Point Six, Inc.

Wireless Analog/Counter Model P6EZIO

Installation and Operation Instructions

Description

The P6EZIO analog/counter module has a battery life of >5years. The pushbutton on the sensor has the following

function:

Transmit service packet: Briefly press while powered up.

This model may be configured as a counter, temperature sensor, humidity sensor or general-purpose analog input.

The specific function is determined at the time of manufacture and is not alterable by the user

To start operation inset a 3.6 Volt Lithium AA cell. The LED will flash each time a packet is transmitted.

Summary of content (5 pages)

PAGE 1
FCC ID: M5ZP6EZIO Installation and Operation Instructions for the Analog/Counter Wireless transmitter P6EZIO . Point Six, Inc. Wireless Analog/Counter Model P6EZIO Installation and Operation Instructions Description The P6EZIO analog/counter module has a battery life of >5years. The pushbutton on the sensor has the following function: Transmit service packet: Briefly press while powered up. This model may be configured as a counter, temperature sensor, humidity sensor or general-purpose analog input.
PAGE 2
Packet Description “MultiAnalog” (75/76) IDSSSSSSSSnnrraaaaAAAACCCCKK Note: All fields are in ASCII Hex “ID” The device type field: MultiAnalog has device type 76 hex. A 75 hex when in service mode. “SSSSSSSS” The MS-30 bits of these 4-bytes are the serial number of the MultiAnalog device. The LS-2 bits are set to zero. “nn” The number of I/O points (1 byte field: 1 or 2). “rr” This 1 byte field is not used and contains generic 00 data.
PAGE 3
Packet Description “CountAnalog” (74/73) IDSSSSSSSSoooooottttLLCCCCKK Note: All fields are in ASCII Hex “ID” The device type field: Counter-Analog-Status has device type 73 hex. A 74 hex when in service mode. “SSSSSSSS” The MS-30 bits of these 4-bytes are the serial number of the Counter-Analog transmitter. The LS-2 bits are the status flags for the switch input status. The LS bit (bit-0) is the Open status flag and the next most significant bit (bit-1) is the Closed status flag.
PAGE 4
Packet Description “Humidity2” (51/52) IDSSSSSSSSnnrrhhhhttttCCCCKK Note: All fields are in ASCII Hex “ID” The device type field: Humidity2 has device type 52 hex. A 51 hex when in service mode. “SSSSSSSS” The MS-30 bits of these 4-bytes are the serial number of the Humidity2 device. The LS-2 bits are set to zero. “nn” Always “00”. “rr” This 1 byte field is not used and contains generic 00 data. “hhhh” This is the humidity data field.
PAGE 5
WARNING: Changes or modifications not expressly approved by the manufacturer for compliance could void the user’s authority to operate this equipment.