User Manual

Table Of Contents

Point Six, Inc. 2333 Alumni Park Plaza - Lexington, KY - 40517- http://www.pointsix.com - 859-266-3606 - Fax 859-266-0702

FCC ID: M5ZIRPROX2

Installation and Operation Instructions for the IR Proximity Counter.

Point Six, Inc.

Wireless IR Proximity Counter Model IRPROX2

Installation and Operation Instructions

Description

The new IRPROX2 people counter has a battery life of >2years. The pushbutton on the sensor has the following

functions:

Power Down: Press and hold the button for > 8 Seconds.

Test power state: Press briefly; LED comes on to indicate power down state.

Power Up : Press for >2 seconds and <8 seconds, LED goes out.

Transmit service packet: Briefly press while powered up.

IR Program: Press and hold the button for >8 seconds while sending IR program parameter commands from IR

transmitter attached to the serial port of a PC running Prox-Programmer software. When an IR command is properly

received and processed the LED will flash to indicate success.

This model has IR ranges of 6,4,3 and 2 feet, switch selectable.

The IR programmability includes:

In-beam time in ¼ second steps to 255 steps. Default: ¼ second.

Out-of-beam time in ¼ second steps to 255 steps. Default: 1 second.

Blocked beam time in ¼ second steps to 255 steps. Default: 16 seconds.

LED flash enable/disable during count. Default: LED flash.

Packet type enable/disable for automatic inclusion of the switch data in a new device type, type "09" the standard

people counter is type "11"

Note: IR programmed parameters are stored in EEPROM and are not lost when replacing the battery.

Note: the LED flashes at other times as normal even if disabled to flash during count.

Note: The packets are micro-randomized for 10 seconds +- 7 (1/4) second intervals.

PAGE 1
FCC ID: M5ZIRPROX2 Installation and Operation Instructions for the IR Proximity Counter. Point Six, Inc. Wireless IR Proximity Counter Model IRPROX2 Installation and Operation Instructions Description The new IRPROX2 people counter has a battery life of >2years. The pushbutton on the sensor has the following functions: Power Down: Press and hold the button for > 8 Seconds. Test power state: Press briefly; LED comes on to indicate power down state.
PAGE 2
Packet Description IDSSSSSSSSooooooccccccCCCCKK Note: All fields are in ASCII Hex “ID” The device type field: “2CountRange” has device type 9 hex. A 8 hex when in service mode. “SSSSSSSS” The MS-30 bits of these 4-bytes are the serial number of the sensor. The LS-2 bits are the status flags for the open and closed limit switches. The LS bit (bit-0) is the Open switch flag and the next most significant bit (bit-1) is the Closed switch flag.
PAGE 3
In Beam : Select the desired in beam time requirement in ¼ second units to a max of 255 units. Out of Beam : Select the desired out of beam time requirement in ¼ second units to a max of 255 units. Blocked Time: Select the desired blocked time requirement in ¼ second units to a max of 255 units. Include Switch Data: Packet type enable/disable for automatic inclusion of the switch data. YES= type "09", NO=type “11” (see packed definition above).