User's Manual

ManualsBrandsPoint Six ManualsElectronicsWireless Counter/Temperature Sensor

FCC ID: M5ZCNT

Installation and Operation Instructions for the Wireless Counter/Temperature.

Point Six, Inc.

Wireless Counter/Temperature Sensor

Model Point Sensor Counter/Temperature

Installation and Operation Instructions

The Point Sensor Counter/Temperature

sensor transmits a digital temperature, relative-

humidity (or light level) and a unique serial number to a 418 MHz receiver. The Point

Sensor Counter/Temperature

is enclosed in a high impact ABS enclosure for direct

surface mounting in the environment to be measured. The Point Sensor

Counter/Temperature

is battery operated.

Application: Apply the sensor to the surface to be monitored with double-sided

adhesive tape. Make sure that the side labeled with FCC ID is visible and away from any

metal surfaces.

Service Function: The wireless sensor has an installation mode switch. A momentary

push of this switch will start the convert/transmit cycles. When new and until this button

is pushed the Point Sensor Counter/Temperature

will not transmit. The Point Sensor

Counter/Temperature will transmit a special installation status mark in the data packet

immediately after the installation/start switch is pushed. After the start a push of the

installation switch will result in the immediate transmission of temperature, counter, ID

and installation status mark.

Battery: A 3.6 Volt lithium battery powers the Point Sensor Counter/Temperature

wireless sensor. The battery will last for more than 10 years in the idle state (as shipped

from the manufacturer). The Point Sensor Counter/Temperature will transmit data for as

long as 5 years at a rate of once each minute once started. The Point Sensor

Counter/Temperature

is completely covered with a water resistant conformal coating to

protect the electronics from the environment and condensation. The user can replace the

battery. The Point Sensor Counter/Temperature

may be placed in a quiescent state

(battery life greater than 10 years) by holding the installation switch closed for more than

4 seconds.

Summary of content (4 pages)

PAGE 1
FCC ID: M5ZCNT Installation and Operation Instructions for the Wireless Counter/Temperature. Point Six, Inc. Wireless Counter/Temperature Sensor Model Point Sensor Counter/Temperature Installation and Operation Instructions The Point Sensor Counter/Temperature sensor transmits a digital temperature, relativehumidity (or light level) and a unique serial number to a 418 MHz receiver.
PAGE 2
FCC ID: M5ZCNT FCC ID: M5ZCNT MADE IN USA THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES, OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESERED OPERATION Wireless Sensor Data Format The Point Six, Inc.
PAGE 3
FCC ID: M5ZCNT 16-bit data field this field contains 12-bit analog data stored in stored MSByte first in 12-bit form this field is unsigned and has a range of 0 to 4095 (0000-0FFF) hex. 2-byte CRC-16 this is the originally received data packet CRC-16 as described above. 1-byte checksum the checksum is a mod 256 sum of all the ASCII character values in the response but does not include the CR; the checksum is added by the HA8 and is not a part of the transmitted data.
PAGE 4
FCC ID: M5ZCNT “KK” This field is the mod 256 sum of all the binary data values as represented by the ASCII hex values in the response but does not include the . FCC Radio Frequency Interference Statement Wireless Counter/Temperature Sensor FCC ID: M5ZCNT NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15, Subpart B, of the FCC Rules. This equipment generates, uses, and can radiate radio frequency energy.