TOF RTLS TECHNOLOGY Reference Guide
Copyright Statement © 2018 PLURITAG inc. All rights reserved. This material may not be reproduced, displayed, modified or distributed without the express prior written permission of the copyright holder. For permission, contact: Pluritag inc. 462 rue Des Forges, Trois-Rivières, Qc ,Canada Phone: 819-372-3336 Warranty Limited Warranty Statement PLURITAG INC.
Introduction PLURITAG’S TOF technology is a RTLS system based on Decawave’s DWM1001 module. This module uses a Decawave’s DW1000 UWB transceiver IC compliant with IEEE-802.15.4-2011. The purpose of the technology is to do indoor localization using readers and tags deployed at a customer’s site. The readers are installed at known positions and tags are used on items that needs to be localized inside plants or buildings.
Reader Software The TOF RTLS Reader is shipped with a web console that can be used to configure the reader. This console is an embedded application that provides the ability to configure the reader across a network. Enter the IP address of the TOF RTLS Reader into a web browser. This application provides the ability to modify the reader’s communication, network, and operational parameters. Reader Installation Figure 1-4 TOF RTLS Reader connection ports. 1. Connect the Ethernet cable to the Ethernet port.
Specifications _______________________________________________ 5
________________________________________________ Power Supply Use ONLY a LISTED, type no SW-10-5-N (5V DC/ 2A max) power supply. Use of alternative Power Supply will invalidate any approvals given to this unit and may be dangerous. Warnings for Use of Wireless Devices Please observe all warnings notices with regard to the usage of wireless devices. Potentially Hazardous Atmospheres You are reminded of the need to observe restrictions on the use of radio devices in fuel depots, chemical plants etc.
Radio Frequency Interference Requirements – FCC Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
FCC and Industry Canada information.
