Product Info

FCC Compliance Notice:

This device complies with Part 15 of the FCC Rules [and with Industry Canada licence-exempt

RSS standard(s)].

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may

cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment.

FCC ID: 2AR2K-0002016

IC ID: TBD

This device is for internal use only and is not expected to be transported to any third parties,

hence no packaging label is necessary. Notwithstanding, in the event any devices are provided to

any third parties, they must be accompanied by a packaging label including the information on

this page.

PAGE 1
FCC Compliance Notice: This device complies with Part 15 of the FCC Rules [and with Industry Canada licence-exempt RSS standard(s)]. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
PAGE 2
CONFIDENTIAL Sprinkles RF testing SOP 1. Connect FTDI cable to your computer and to the board following the attached picture for orientation. 2. Setup your favorite serial terminal to access the FTDI cable using the following settings: baud = 115200, bytes = 8, parity = None, stop bits = 1. 3. Apply power by inserting jumper in the last two free pins in the header. The complete setup should appear as in the picture bellow: 4.
PAGE 3
CONFIDENTIAL Here are the available commands: r+ [channel] [power] the 'r+' command takes two optional arguments: the first one is the channel in the range [11-26] and the second one is Tx power in dBm. Default channel: 20. Default power +8dBm. [Note the standard Sprinkles firmware during defaults to -8dBm but allows setting the power higher] rc the 'rc' command sets the radio in CW mode. To stop this mode of operation you need to power cycle the board.