User's Manual

- Small parts
CHOKING HAZARD
Not for children under 3 years
WARNING:
CONTENT:
RC CONTROLLER
ANTENNA...................x 1PC
REMOTE CONTROL.....x 1PC
GUN............................x 1PC
ROBOT........................x 1PC
Features:
- Remote Controlled Transbotix
with full function and 27 mhz.
(Truck Mode)
- Robot Mode Transforms Into
Truck Mode
- Poseable Robot with Detachable
Accessories
TRANSBOTIX ROBOT:
TO REPLACE BATTERIES REFER TO THE FOLLOWING DIRECTIONS & ILLUSTRATION:
1. Push the “ON/OFF” button to “OFF” position. ( Pic.1 )
2. Use a phillips screwdriver to loosen and remove the screw of the battery compartment
door as shown.
3. Remove the battery compartment door. ( Pic.2)
4. Remove old batteries and replace with 4 new “AAA” batteries following the (+) and (-)
positioning stated in the battery compartment. Dispose of old batteries properly. ( Pic.3 )
5. Fasten the screw to secure battery compartment door.
FCC STATEMENTS
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential
installation. This equipment generated, uses and can radiate radio frequency energy and if not installed and used in
accordance with the instructions, may cause harmful to radio communications.
However, these is no guarantee that interference will not occur in a particular installations. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measure:
• Reorient of relocate the receiving antenna.
• Increase the seperation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that tot which the receiver is needed.
• Consult the dealer or an experienced radio/TV technician for help.
• Warning: Changes of modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
• This product is compliance with the essential requirements and other relevant provisions of directive 1995/5/EC
Color & contents may vary.
Please keep this packaging for future reference. Conforms to the safety requirements
of ASTM F963 and EN-71
BATTERY CAUTION
1) Rechargeable batteries are not recommended.
2) Non-rechargeable batteries are not to be recharged.
3) Rechargeable batteries are to be removed from the toy before being charged.
4) Rechargeable batteries are only to be charged under adult supervision.
5) Do not mix alkaline, standard (carbon-zino), or rechargeable (nickel-cadmium) batteries.
6) Do not mix old and new batteries.
7) Only batteries of the same or equivalent types as recommended are to be used.
8) Batteries are to be inserted with the correct polarity.
9) The supply terminals are not to be short-circuited.
10) If the batteries are loose, bend out the contacts for a tight fit.
11) Exhausted batteries are to be removed from the toy and be disposed of immediately; never dispose of batteries in fire.
12) If storing product for long periods of time, make sure to remove batteries.
13) Check the product periodically for signs of damage to electrical parts; do not play with
product until damage has been properly assessed.
BATTERIES INCLUDED ARE FOR IN-STORE DEMONSTRATIONS ONLY.
PLEASE REPLACE OLD BATTERIES WITH NEW BATTERIES BEFORE USE.
If the unit malfunctions, please remove the batteries for one minute and reinstall again.
If the malfunctions persist, please replace with new batteries.
BATTERIES SHOULD BE INSTALLED BY ADULTS ONLY.
Rechargeable batteries are not recommended.
R/C CONTROLLER:
TO REPLACE BATTERIES REFER TO THE FOLLOWING DIRECTIONS & ILLUSTRATION:
1. Use a phillips screwdriver to loosen and remove the screw of the battery compartment
door as both sides. ( Pic.1 )
2. Remove the battery compartment door.
3. Remove old batteries and replace with . 1 new “6F22” 9V batteries following the (+) and (-)
positioning stated in the battery compartment. Dispose of old batteries properly. ( Pic.2 )
4. Fasten the screw to secure battery compartment door .
P.1
P.2
( Pic.1 )
( Pic.2 )
( Pic.3 )
6F22
9V
( Pic.2 )
( Pic.1 )
(BATTERIES NOT INCLUDED)
Don’t Put In Trash. Recycle or
Dispose as Hazardous Waste.
1.5V X 4
AAA
9V X 1
9V
Requires 4 x 1.5v AAA
batteries for Transbotix
and 1x9v battery for
transmitter (not included)
HOW TO MOVE - FORWARD HOW TO MOVE - BACKWARD
HOW TO TURN - LEFT
HOW TO TURN - RIGHT
Press the upper left
and forward button at
the same time to
move forward.
Press the lower left
and right backward
button at the same
time to move backward.
Press the upper left
forward button to
turn RIGHT.
Press the upper right
forward button to
turn LEFT.
ANTENNA
POWER OFF/ON
FORWARD
RIGHT
FORWARD
LEFT
BACKWARD
RIGHT
BACKWARD
LEFT