User's Manual

Introduction

Thank you for purchasing GameStick. Before starting, please take a couple of minutes to read this guide to setting up

and using GameStick.

What’s in the box

• 1 x GameStick (A)

• 1 x Controller (B)

• 1 x Mains Power Supply Unit (region specific) (C)

• 1 x 1m USB to Micro USB Power Cable (for controller) (D)

• 1 x 30cm Y Cable from Micro USB to Regular USB (type A) (For Stick) (E)

• 1 x HDMI Extender Cable (F)

You will need

• Wireless internet connection

• TV with HDMI port

• Access to a device with an internet browser for one-time registration

Controller Map

Shoulder buttons BT Pairing Power button

D Pad Charge points

Home button LED Indicator Strip

Reset Micro USB port

Charge your Controller

We recommend that you fully charge the controller before using for the first time. To do this:

• Plug cable (D) into the Micro USB port (N) on the front of the controller.

• Plug the other end of cable (D) into any powered USB port e.g. on TV, PC or Y cable (E) as per figure 3.

• All 4 LED lights will flash at once whilst the controller is charging.

• When all four lights remain on, the controller is fully charged.

Set up your GameStick

• Power GameStick using the included Y Cable (E) & Power Supply (C) per Figure 3. A white light from within the

stick indicates power.

• Plug GameStick into TV’s HDMI port (use the extender cable (F) provided if required).

• Switch on controller by pressing and holding the power button (O) for 3 seconds and follow Controller Pairing

instructions below.

• Once the controller is paired, follow the one-time on-screen device and account setup instructions.

Controller Pairing

When you turn on your controller, it will automatically enter pairing mode then connect. Pairing mode is indicated by a

flashing light on LED Indicator Strip (M). When paired, the light will stop flashing and remain solid.

GameStick supports up to four controllers simultaneously. Successfully connected controllers are represented by

additional solid lights on LED Indicator Strip (M).

If pairing your controller for the first time, GameStick will scan for available controllers. Once it has detected your

controller, you will be prompted to press button A to pair that device. This process should take approximately 30

seconds.

Troubleshooting - If your controller fails to pair, first try rebooting your GameStick by disconnecting then

reconnecting power and trying again. If this is unsuccessful you will need to reset your controller. To do this, press the

PAGE 1
Introduction Thank you for purchasing GameStick. Before starting, please take a couple of minutes to read this guide to setting up and using GameStick.
PAGE 2
recessed Reset button (J) on the back of the controller which will turn the device off. Turn the controller back on and wait for GameStick to scan and find the controller, you will then be prompted to press button A to pair that device. Need more help? For more information and further support go to www.gamestick.tv/support. Looking after GameStick Whilst every precaution has been taken to ensure your safety, every electrical device should be handled with care at all times.
PAGE 3
FCC Radiation Exposure Statement The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must be co‐located for operating in conjunction with any other antenna or transmitter. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s a uthority to operate the equipment. For warranty information please visit www.gamestick.tv/warranty Android is a trademark of Google inc.