User Manual
Instructions
1) To unlock the Tele-Titan, squeeze handle and hold
while pushing lock pin to other side. (Fig 1).
Release handle. Ready to terminate!
2) Prep the cable:
A. To strip at satin, insert thru the 2 strip blades and
out past the cut side. Squeeze handle down, slightly
release & hold. Pull cable out & away from tool
(Fig2a). When stripping 4 or 6 conductor at satin,
re-cut conductor’s to 1/4”. Use cutter on cut side.
(Fig 2c).
2b
1
www.platinumtools.com
©2011 Platinum Tools Inc. All rights reserved. 12507C 8/11
2a
3
Locked Unlocked
2c
B. To strip twisted pair, insert into round stripping
cavity. (Fig 2b). Squeeze handle until blade slightly
cuts jacket, hold, rotate tool clockwise & cable
counterclockwise.
NOTE: scoring the jacket prevents
nicking the conductors! Untwist pairs, remove kinks,
congure to spec A or B. Use cutter to trim, 1/2” for
Cat5e & 3/16” for CAT6.
3) Terminate the connector:
A. Insert the prepped cable into the proper crimp
cavity/port, 8P for the RJ45’s and 6P for the
RJ12’s and RJ11’s. See (Fig 3).
B. Make sure connector is fully seated into the
crimp cavity/port and hold in position until crimped.
C. Squeeze handle all the way down until it bottoms
out. See (Fig 4). Termination is complete!
4
NOTE:
Replacement
blade sets
are available.
Order PN 12507BLC