User Manual Model Name: PF302
General Speaker Setup & Pairing: ‐ Select a BT 2.0 or above device (mobile phone or music player) for pairing. ‐ Turn on the Main Power Switch of PF302 at the back. Remark: Make sure your PF302 has been fully charged. ‐ Activate your BT device to the searching mode (new device searching). ‐ Press and hold “Stand-by or Phone & Phone” key at the side of PF302 till the flashing of BLUE/RED LED, PF302 will have 3mins (searchable time) for your BT device to pair with.
‐ To Toggle in between 3rd Party/Original call: Double Press “Stand-by or Phone” key at the side ‐ To Redial Last Calling number: Double Press “Stand-by or Phone” key at the side Remark: PF302 could perform as a speaker phone, ONLY HFP/HSP is available in your BT mobile, Battery Recharge & Firmware Upgrade Instruction: ‐ PF302 could be recharged in any status by USB power (thru the provided USB cable from PC; or from USB adaptor “Not included”) ‐ PF302 firmware upgrade is available thru USB cable fro
BT device LED No Power Sound is Too small / too much distortion ‐ Make sure PF302 Main Switch is ON ‐ Make sure PF302 is charged.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.