THE BLASTER PORTABLE WIRELESS SPEAKER user manual MANUEL DE L’UTILISATEUr nixon.
LISTEN IMPORTANT SAFETY INFORMATION Failure to use common sense while enjoying The Blaster may cause permanent damage to the speaker, yourself and/or others. • DO NOT expose to excessive moisture. This includes water, beer, any other liquids, or super wet environments. To clean, wipe down dirty surfaces with a lightly damp cloth then let dry. Do not use chemical cleaners or run directly under water. • DO NOT expose to me high or low temperatures.
FEATURES CONTENTS - Wireless connectivity via Bluetooth® with most smartphones and computers - Seamless rubber construction with built-in resistance to dirt and moisture - Precision-tuned acoustics for big, full sound and ultra-low distortion - Rechargeable battery with extra capacity for up to 12 hours of continuous play - On-board volume and playback buttons for remote control of your music - Integrated microphone for hands-free wireless voice calls on most smartphones - Auxiliary stereo input to connec
POWER IT UP hold 1 second Press and hold the Power Button for 1 second then release to power ON The Blaster. SYNC IT UP hold 1 second Press and hold the Multi Button for 1 second then release to enter Bluetooth © Pairing Mode, indicated by flashing blue LED. The Power LED will illuminate solid red. Locate the Bluetooth settings on your music device, enable Bluetooth, and select “NIXON BLASTER“ from the list of local Bluetooth devices. Press the Power Button again for 1 second then release to power OFF.
CRANK IT UP SWITCH IT UP Use the Volume Up and Volume Down buttons to set the playback level of The Blaster. You can control many functions of your music device directly from The Blaster when connected via Bluetooth. TIP: Because the volume control buttons of The Blaster do not control the volume output of your music device, you must properly adjust the volume settings of each device independently.
TALK IT UP CHARGE IT UP You can also use The Blaster as a “speakerphone” when connected via Bluetooth. Incoming and outgoing calls will automatically pause music playback, then resume when the call is ended. Connect the USB Charging Cable between The Blaster and a USB port on a notebook or desktop computer, or use the included USB to AC adapter. While charging, the Power LED will flash in a repeating pattern to indicate the current battery status as shown on the next page.
BATTERY CHECK WARRANTY press Press the Power Button once then release. The Power LED will turn off briefly, and then flash in a repeating pattern to indicate the battery status. 100% RED 75% RED 50% RED 25% RED LOW YELLOW TIP: Because the volume control buttons of The Blaster do not control the volume output of your music device, you must properly adjust the volume settings of each device independently.
CONTACT To find a service center close to you Go to: Nixon.com Select your country / support / service Nixon will involve you returning the defective goods to us, at your expense. FCC COMPLIANCE AND ADVISORY STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device complies with Industry Canada license-exempt RSS standard(s).