Item Number: 28006 NICHOLS POOL TABLE WARNING: DO NOT ATTEMPT TO ASSEMBLE IF PARTS ARE MISSING OR DAMAGED. IMPROPER ASSEMBLY MAY RESULT IN DAMAGE OR SERIOUS INJURY! Please read the following instructions carefully prior to assembly.Check the parts list to make sure you have all the parts needed for proper assembly.
PARTS LIST (1) DESCRIPTION PICTURE QTY SIZE H1 leg 2 1000*200*320 H2 support beam 1 2140*180*150 H3 short beam 2 1936*180*65 H4 long beam 2 1173*180*65 H5 middle beam 2 893*120*40 H6 side slate1 1 805*1295*43 H7 middle slate 1 805*1295*43 H8 side slate2 1 805*1295*43 H9 cloth 1 H10 1、4# rail 2 1083*164*43 H11 2、5#rail 2 1111*164*43 H12 3、6#rail 2 1101*164*43 H13 Corner 4 190*190*43 H14 long panel 2 2542*140*50 H15 short panel 2 1423*140*50 2
PART DESCRIPTION A PARTS LIST(2) PICTURE QTY SIZE hex bolt 4 ø10*25 B flat washer 4 M12 C semicircle screw nut 4 M12 D flat washer 4 M12*30*2 E hex bolt 4 ø12*180 F flat head screw 4 4.
Steps 1 Put the legs on floor,pls put the side with screw hole upward. Assembly the legs and support beam, lock it by bolt A and nut B. Turn it over after assembled. Steps 2 Assemble short beam(H3) and long beam(H4) by using bolt (E),washer(D) and semicircle nut(C) accordingly; lock it tightly. Then put the middle beam(H5) in the notch of long beam, and lock it with screw (F).
Steps 3 Put supporting beam on table legs and match the holes. Lock it tightly by using hexagon head bolt (G) and flat washer (H) . Steps 4 Put the slate leveling bolt(J/I) into nuts, keep them on the same level of beams.
Steps 5 Put the slate (H6,H7,H8) above the table frame, and secure it with screw (K) after leveling the slate, then clean it up and put on the cloth(H9).
Steps 7 Put the top rails(H10、H11、H12)and corners (H13) on floor accoringly.Lock it by bolt P,washer O,N and nut M. Note: upper side of rail shoul be put agaist the floor. Steps 8 Assembly the long apron(H15) and shourt apron(H16)accordingly, lock it by bolt Q and washer O.
Steps 9 Put the assembled apron frame on rails, lock it by bolt Q and washer O. Steps 10 After completing step 9, turn the table rail by 180 degrees, and put it above the slate. Using hexagon head bolt (R) to lock into long rail through washer (S) and slate(H6、H7、H8).
Steps 11 Install the leather pockets (U and T) and secure them with 2 pcs of stainless nails(V).