3G/LTE Wireless Data Terminals Series User Manual - For UFI & Modem
Description on Wireless Data Terminal ("UFI") Appearance The appearance of this product is shown in the figure below. The picture is only for reference, and the actual product may differ in reality. SIM card slot USB interface TF card slot Wifi status indicator Power supply and connection Indicator Description of Indicator Status The yellow light is the indicator for WIFI. When WiFi is enabled, the yellow indicator lights up. When WIFI is disabled, the yellow indicator will turn off.
Usage Scenarios Scenario One- Supply power through a computer's USB interface: Power can be supplied to the UFI through a computer's USB interface and UFI will work as a network adapter for the computer. If the computer is connected to the network via a USB interface, then it does not need to establish a WIFI connection (installation of the driver is required) to be connected to the network. At the same time, the WiFi-enabled terminal equipment around it can be connected to the network via UFI.
Note: Your device does not support Micro / Nano SIM cards or other non-standard SIM cards. Please do not input any other card sizes other than a standard SIM card, as it may damage the card slot. Installation of SIM card and micro SD card 3. UFI Computer Driver Installation Open the USB cap of UFI to insert the USB interface into the USB port of your computer. The operating system will automatically recognize the new hardware and begin to install the software.
4. Write down the name of your WiFi network and WiFi password on the body tag of your device. SSID:PH4G-XXXX Password:1234567890 5. Using a Cell Phone to Connect to a Wireless Data Terminal UFI Enter the phone settings and enable your phone Wi-Fi to search for "PH4G-XXXX" (where XXXX are the last four numbers of your MAC address). Follow the prompts to enter the password and click "Connect" to join. Configuration of Wireless Data Terminal 1.
3. Modification of the WiFi Name and Password You can change the name and the connection password of WiFi after logging in WEB management interface and turn to wireless →wireless security settings. 4. Flow Control Settings You can control and manage the traffic of your SIM card through Internet→traffic settings. Tips: Traffic is only for reference. It is recommended that you ask operator for accurate traffic.
5. Connection / Disconnection from the Network UFI will power down automatically and then be disconnected from the network when it is removed from the power supply of USB. Turn to system status page after logging in WEB management interface. Click "Disable" if you want to disconnect your UFI from the internet. Click "Enable" to connect your UFI to the Internet. Note: Product images are for reference only, subject to change without notice.
FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Consult the dealer or an experienced radio/TV technician for help. SAR Information Statement Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population.
described in this user guide, is 0.560W/Kg(Body-worn measurements differ among phone models, depending upon available accessories and FCC requirements). While there may be differences between the SAR levels of various phones and at various positions, they all meet the government requirement for safe exposure. The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in compliance with the FCC RFexposure guidelines.
