Installation Instructions

FCC Statement

This device complies with part 15 and part 18 of the FCC Rules. Operation is

Subject To the following two conditions:

(1) This device may not cause harmful interference, and (2) this devicemust

accept any interference received, including interference that may cause

undesired operation. Changes or modifications not explicitly approved by

the partyresponsible for compliance could void the user's authority tooperate

this equipment.

Note: this equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 and part 18 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and

canradiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference toradio or

television reception, which can be determined by turning the equipment off

and on, the user is encouraged totry to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

The equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. During the operation of device a distance of 15 cm

surrounding the device and 20 cm above the top surface of the device must

be respected.

This device complies with Part 18 of the FCC Rules. This equipment generates

uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio

communications. If this equipment does cause harmful interference to radio

or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one

or more of the following measures:

● Increase the separation between the equipment and any other radio device.

● Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

FOD

N S

1 x 2 in 1 Magnetic Mount 1 x Suction Cup Car Mount

PAGE 1
S 1 x Suction Cup Car Mount N 1 x 2 in 1 Magnetic Mount FOD FCC Statement This device complies with part 15 and part 18 of the FCC Rules. Operation is Subject To the following two conditions: (1) This device may not cause harmful interference, and (2) this devicemust accept any interference received, including interference that may cause undesired operation. Changes or modifications not explicitly approved by the partyresponsible for compliance could void the user's authority tooperate this equipment.