BLACKVUE DR650S-2CH For manuals, customer support and FAQs go to www.blackvue.
Important safety information For user safety and to avoid property damage, read through this manual and follow these safety instructions to use the product correctly. yy Do not disassemble, repair, or modify the product yourself. Doing so may cause fire, electric shock, or malfunction. For internal inspection and repair, contact the service center. yy Do not adjust the product while driving. Doing so may cause an accident. Stop or park your car in a safe place before installing and setting up the product.
FCC Compliance Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protections against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
CAUTION Any changed or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. There is a risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. CE WARNING yy Changes and modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Disposal of your BlackVue dashcam 1. All electrical and electronic products should be disposed of separately from the municipal waste stream via designated collection facilities appointed by the government or the local authorities. Contact local authorities to learn about disposal and recycling options available in your area. 2. The correct disposal of your BlackVue dashcam will help prevent potential negative consequences for the environment and human health. 3.
In the box Check the box for each of the following items before installing the BlackVue dashcam. Front camera Quick start guide Power cord Cable clips (8 EA) Double-sided tape for the Mounting Brackets microSD Card microSD card reader Rear camera Rear camera connection cable Pry tool Need help? Download the manual (including FAQs) and the latest firmware from www.blackvue.com Or contact a Customer Support expert at cs@pittasoft.
At a glance The following diagrams explain each part of the BlackVue dashcam. Front camera 118.5 mm Camera lens 36 mm 55 mm Lock button Mounting bracket Front security LED :B links slowly in normal and parking mode. : Blinks quickly when (i) an event is being recorded (impact detected), (ii) manual recording has started, or (iii) motion is detected in parking mode. QR Code: Used to register your camera for the Cloud Service (leave attached for easy access).
Wi-Fi/Internet LED : Direct Wi-Fi is on. : Blinks when connected to the internet (Cloud connected). Manual recording proximity sensor: Touch or wave a finger within 20mm of the sensor to start a manual recording. Rear camera connection port DC in (power connector) Cover microSD card slot Wi-Fi / Format button * Self-format function: To format the microSD card press the button for 10 seconds until the dashcam beeps.
Rear camera Camera lens 25 mm 31 mm Mounting bracket 67.4 mm V out (Front camera connection port) 10 BLACKVUE Rear security LED : Rear camera is on (on in all recording modes).
STEP 1 Install and power up Install the front camera behind the rear view mirror. Install the rear camera at the top of the back windshield. Remove any foreign matter and clean and dry the windshield before installation. Warning yy Do not install the product in a location where it can obstruct the driver's field of vision. Turn off the engine. Peel off the protective film from the double-sided tape and attach the front camera to the windshield behind the rear-view mirror.
Peel off the protective film from the double-sided tape and attach the rear camera to the rear windshield. Adjust the angle of the lens by rotating the body of the rear camera. Connect the front camera ('Rear' port) and the rear camera ('V out') using the rear camera connection cable. Use the pry tool to lift the edges of the rubber window sealing and molding and tuck in the rear camera connection cable.
Turn on the engine. The BlackVue dashcam will power up and start recording. Video files are stored on the microSD card. When the microSD card fills up, the newest video files will start to replace the oldest video files (called loop recording) – so you will always have the most recent video files. Note yy The recording LED blinks while recording (default setting) and the GPS LED is on when a GPS signal is received. There are 4 recording modes: Normal, Event, Parking and Manual.
STEP 2 Playback Playing video files on your smartphone (Android/iOS) Search for the BlackVue C app in the Google Play Store or Apple App Store and install it on your smartphone. “Pair” your smartphone with the BlackVue dashcam via direct Wi-Fi: (i) Go to your smartphone’s Settings then select Wi-Fi, and make sure Wi-Fi is turned on. (ii) Choose your BlackVue dashcam from the network list. The dashcam’s default SSID begins with its model number (e.g. DR650S-******).